[PATCH V2 net-next 1/2] dt-bindings: net: tja11xx: add nxp,refclk_in property

[wei . fang]

From: Wei Fang <wei.fang@xxxxxxx>

TJA110x REF_CLK can be configured as interface reference clock
intput or output when the RMII mode enabled. This patch add the
property to make the REF_CLK can be configurable.

Signed-off-by: Wei Fang <wei.fang@xxxxxxx>
---
V2 change:
Correct the property name and a typo.
---
 .../devicetree/bindings/net/nxp,tja11xx.yaml    | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/nxp,tja11xx.yaml b/Documentation/devicetree/bindings/net/nxp,tja11xx.yaml
index d51da24f3505..ab8867e6939b 100644
--- a/Documentation/devicetree/bindings/net/nxp,tja11xx.yaml
+++ b/Documentation/devicetree/bindings/net/nxp,tja11xx.yaml
@@ -31,6 +31,22 @@ patternProperties:
         description:
           The ID number for the child PHY. Should be +1 of parent PHY.
 
+      nxp,rmii-refclk-in:
+        type: boolean
+        description: |
+          The REF_CLK is provided for both transmitted and received data
+          in RMII mode. This clock signal is provided by the PHY and is
+          typically derived from an external 25MHz crystal. Alternatively,
+          a 50MHz clock signal generated by an external oscillator can be
+          connected to pin REF_CLK. A third option is to connect a 25MHz
+          clock to pin CLK_IN_OUT. So, the REF_CLK should be configured
+          as input or output according to the actual circuit connection.
+          If present, indicates that the REF_CLK will be configured as
+          interface reference clock input when RMII mode enabled.
+          If not present, the REF_CLK will be configured as interface
+          reference clock output when RMII mode enabled.
+          Only supported on TJA1100 and TJA1101.
+
     required:
       - reg
 
@@ -44,6 +60,7 @@ examples:
 
         tja1101_phy0: ethernet-phy@4 {
             reg = <0x4>;
+            nxp,rmii-refclk-in;
         };
     };
   - |
-- 
2.25.1