Re: [PATCH v4 3/6] iommu/mediatek: Add error path for loop of mm_dts_parse

[Yong Wu]

Hi Dan,

Thanks very much for your review:)

On Tue, 2022-08-30 at 11:32 +0300, Dan Carpenter wrote:
> On Wed, Aug 24, 2022 at 02:43:03PM +0800, Yong Wu wrote:
> > The mtk_iommu_mm_dts_parse will parse the smi larbs nodes. if the
> > i+1
> > larb is parsed fail, we should put_device for the 0..i larbs.
> > 
> > There are two places need to comment:
> > 1) The larbid may be not linear mapping, we should loop whole
> >    the array in the error path.
> > 2) I move this line position: "data->larb_imu[id].dev = &plarbdev-
> > >dev;"
> >    That means set data->larb_imu[id].dev before the error path.
> >    then we don't need "platform_device_put(plarbdev)" again while
> >    probe_defer case. All depend on "put_device" in the error path
> > in error
> >    cases.
> 
> I don't understand what you're saying here.  There is still a
> platform_device_put(plarbdev) on the success path after
> component_match_add().
> 
> So if we fail when i == 2 then we do:
> 
> 	put_device(data->larb_imu[2].dev);
> 
> But for the previous iterations has both platform_device_put()
> and put_device() called for them.

Sorry for this. Right! For the goto outside the loop, it did put twice.
I will fix this.

> 
> regards,
> dan carpenter
>