Re: [PATCH 1/2] thermal: Introduce CONFIG_QCOM_THERMAL in Makefile and qcom/Kconfig

[Dmitry Baryshkov]

On Sun, 11 Sept 2022 at 21:42, Bhupesh Sharma <bhupesh.sharma@xxxxxxxxxx> wrote:
>
> Introduce CONFIG_QCOM_THERMAL to allow better control
> over selection of various Qualcomm Thermal drivers
> available inside qcom/ directory.
>
> This is a preparatory change to allow new drivers to
> be added inside qcom/ directory in a more structured
> fashion.
>
> Cc: Bjorn Andersson <andersson@xxxxxxxxxx>
> Cc: Daniel Lezcano <daniel.lezcano@xxxxxxxxxx>
> Cc: Amit Kucheria <amitk@xxxxxxxxxx>
> Cc: Thara Gopinath <thara.gopinath@xxxxxxxxx>
> Signed-off-by: Bhupesh Sharma <bhupesh.sharma@xxxxxxxxxx>
> ---
>  drivers/thermal/Makefile     |  2 +-
>  drivers/thermal/qcom/Kconfig | 12 ++++++++++++
>  2 files changed, 13 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/thermal/Makefile b/drivers/thermal/Makefile
> index def8e1a0399c..a12b647be0d1 100644
> --- a/drivers/thermal/Makefile
> +++ b/drivers/thermal/Makefile
> @@ -52,7 +52,7 @@ obj-$(CONFIG_DA9062_THERMAL)  += da9062-thermal.o
>  obj-y                          += intel/
>  obj-$(CONFIG_TI_SOC_THERMAL)   += ti-soc-thermal/
>  obj-y                          += st/
> -obj-$(CONFIG_QCOM_TSENS)       += qcom/
> +obj-$(CONFIG_QCOM_THERMAL)     += qcom/

Following other platforms around qcom, I think just `obj-y += qcom/`
would work well enough.

>  obj-y                          += tegra/
>  obj-$(CONFIG_HISI_THERMAL)     += hisi_thermal.o
>  obj-$(CONFIG_MTK_THERMAL)      += mtk_thermal.o

-- 
With best wishes
Dmitry