[PATCH v2 1/2] soundwire: qcom: update status from device id 1

[Srinivas Kandagatla]

By default autoenumeration is enabled on QCom SoundWire controller
which means the core should not be dealing with device 0 w.r.t enumeration.

During Enumeration if SoundWire core sees status[0] as SDW_SLAVE_ATTACHED and
start programming the device id, however reading DEVID registers return zeros
which does not match to any of the slaves in the list and the core attempts
to park this device to Group 13.  This results in adding SoundWire device
with enumeration address 0:0:0:0

Fix this by not passing device 0 status to SoundWire core.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@xxxxxxxxxx>
---
Changes since v1:
	- updated change log and split patch in to two as suggested by Pierre

 drivers/soundwire/qcom.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/soundwire/qcom.c b/drivers/soundwire/qcom.c
index e7f95c41eb70..d3ce580cdeaf 100644
--- a/drivers/soundwire/qcom.c
+++ b/drivers/soundwire/qcom.c
@@ -448,7 +448,7 @@ static void qcom_swrm_get_device_status(struct qcom_swrm_ctrl *ctrl)
 	ctrl->reg_read(ctrl, SWRM_MCP_SLV_STATUS, &val);
 	ctrl->slave_status = val;
 
-	for (i = 0; i <= SDW_MAX_DEVICES; i++) {
+	for (i = 1; i <= SDW_MAX_DEVICES; i++) {
 		u32 s;
 
 		s = (val >> (i * 2));
-- 
2.21.0