[PATCH v3 net-next 08/10] mips: dts: ralink: mt7621: change mt7530 switch address

[Arınç ÜNAL]

In the case of muxing phy0 of the MT7530 switch, the switch and the phy
will have the same address on the mdio bus, 0. This causes the ethernet
driver to fail since devices on the mdio bus cannot share an address.

Any address can be used for the switch, therefore, change the switch
address to 0x1f.

Suggested-by: Sungbo Eo <mans0n@xxxxxxxxxx>
Signed-off-by: Arınç ÜNAL <arinc.unal@xxxxxxxxxx>
Reviewed-by: Sergio Paracuellos <sergio.paracuellos@xxxxxxxxx>
---
 arch/mips/boot/dts/ralink/mt7621.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/mips/boot/dts/ralink/mt7621.dtsi b/arch/mips/boot/dts/ralink/mt7621.dtsi
index 3d4a8e4bd4f8..7900760212c9 100644
--- a/arch/mips/boot/dts/ralink/mt7621.dtsi
+++ b/arch/mips/boot/dts/ralink/mt7621.dtsi
@@ -340,9 +340,9 @@ mdio: mdio-bus {
 			#address-cells = <1>;
 			#size-cells = <0>;
 
-			switch0: switch@0 {
+			switch0: switch@1f {
 				compatible = "mediatek,mt7621";
-				reg = <0>;
+				reg = <0x1f>;
 				mediatek,mcm;
 				resets = <&sysc MT7621_RST_MCM>;
 				reset-names = "mcm";
-- 
2.34.1