Re: [PATCH v1 2/3] drivers/perf: add DesignWare PCIe PMU driver

[Bjorn Helgaas]

[+cc linux-pci]

On Sat, Sep 17, 2022 at 08:10:35PM +0800, Shuai Xue wrote:
> This commit adds the PCIe Performance Monitoring Unit (PMU) driver support
> for T-Head Yitian SoC chip. Yitian is based on the Synopsys PCI Express
> Core controller IP which provides statistics feature. The PMU is not a PCIe
> Root Complex integrated End Point(RCiEP) device but only register counters
> provided by each PCIe Root Port.
> 
> To facilitate collection of statistics the controller provides the
> following two features for each Root Port:
> 
> - Time Based Analysis (RX/TX data throughput and time spent in each
>   low-power LTSSM state)
> - Event counters (Error and Non-Error for lanes)
> 
> Note, only one counter for each type.
> 
> This driver add PMU devices for each PCIe Root Port. And the PMU device is
> named based the BDF of Root Port. For example,
> 
>     10:00.0 PCI bridge: Device 1ded:8000 (rev 01)
> 
> the PMU device name for this Root Port is pcie_bdf_100000.
> 
> Example usage of counting PCIe RX TLP data payload (Units of 16 bytes)::
> 
>     $# perf stat -a -e pcie_bdf_200/Rx_PCIe_TLP_Data_Payload/
> 
> average RX bandwidth can be calculated like this:
> 
>     PCIe TX Bandwidth = PCIE_TX_DATA * 16B / Measure_Time_Window
> 
> Signed-off-by: Shuai Xue <xueshuai@xxxxxxxxxxxxxxxxx>

> +++ b/drivers/perf/dwc_pcie_pmu.c
> ...
> +#define DWC_PCIE_VSEC_ID			0x02

I don't think DWC_PCIE_VSEC_ID is a very good name because it doesn't
tell us anything about the purpose of the capability.  Something like
DWC_PCIE_RAS_DES_VSEC_ID would be more useful to readers.

> +#define DWC_PCIE_LINK_CAPABILITIES_REG		0xC
> +#define DWC_PCIE_LANE_SHIFT			4
> +#define DWC_PCIE_LANE_MASK			GENMASK(9, 4)

Shouldn't need these at all; see below.

> +struct dwc_pcie_info_table {
> +	u32 bdf;
> +	u32 cap_pos;

Would be useful to name this "ras_des" or similar so we have a hint
about what we're reading/writing when using "pcie_info->cap_pos" below.

> +static struct device_attribute dwc_pcie_pmu_cpumask_attr =
> +__ATTR(cpumask, 0444, dwc_pcie_pmu_cpumask_show, NULL);

DEVICE_ATTR_RO()?

> +#define _dwc_pcie_format_attr(_name, _cfg, _fld)				\
> +	(&((struct dwc_pcie_format_attr[]) {{				\
> +		.attr = __ATTR(_name, 0444, dwc_pcie_pmu_format_show, NULL),	\

Ditto.

> +#define DWC_PCIE_EVENT_ATTR(_name, _type, _eventid, _lane)		\
> +	(&((struct dwc_pcie_event_attr[]) {{				\
> +		.attr = __ATTR(_name, 0444, dwc_pcie_event_show, NULL),	\

Ditto.

> +static int dwc_pcie_pmu_discover(struct dwc_pcie_pmu_priv *priv)
> +{
> +	int val, where, index = 0;
> +	struct pci_dev *pdev = NULL;
> +	struct dwc_pcie_info_table *pcie_info;
> +
> +	priv->pcie_table =
> +	    devm_kcalloc(priv->dev, RP_NUM_MAX, sizeof(*pcie_info), GFP_KERNEL);
> +	if (!priv->pcie_table)
> +		return -EINVAL;
> +
> +	pcie_info = priv->pcie_table;
> +	while ((pdev = pci_get_device(PCI_ANY_ID, PCI_ANY_ID, pdev)) != NULL &&
> +	       index < RP_NUM_MAX) {
> +		if (!pci_dev_is_rootport(pdev))
> +			continue;
> +
> +		pcie_info[index].bdf = dwc_pcie_get_bdf(pdev);
> +		pcie_info[index].pdev = pdev;
> +
> +		if (dwc_pcie_find_ras_des_cap_position(pdev, &where))
> +			continue;
> +
> +		pcie_info[index].cap_pos = where;
> +
> +		pci_read_config_dword(pdev,
> +				pdev->pcie_cap + DWC_PCIE_LINK_CAPABILITIES_REG,
> +				&val);
> +		pcie_info[index].num_lanes =
> +			(val & DWC_PCIE_LANE_MASK) >> DWC_PCIE_LANE_SHIFT;

I think you can use pcie_get_width_cap() here.

> +static int dwc_pcie_pmu_set_event_id(struct dwc_pcie_info_table *pcie_info,
> +				     int event_id)
> +{
> +	int ret;
> +	u32 val;
> +
> +	ret = dwc_pcie_pmu_read_dword(pcie_info, DWC_PCIE_EVENT_CNT_CTRL, &val);
> +	if (ret) {
> +		pci_err(pcie_info->pdev, "PCIe read fail\n");

Maybe #define dev_fmt above to add a prefix to these messages?
Otherwise I think they will look like:

  pcieport 0000:00:1c.0: PCIe read fail

which suggests it's related to pcieport, but that's the wrong place to
look.

I think every caller of dwc_pcie_pmu_read_dword() makes the same check
and prints the same message; maybe the message should be moved inside
dwc_pcie_pmu_read_dword()?

Same with dwc_pcie_pmu_write_dword(); moving the message there would
simplify all callers.

> +static int dwc_pcie_pmu_event_enable(struct dwc_pcie_info_table *pcie_info,
> +				     u32 enable)
> +{
> +	u32 ret;
> +	u32 val;
> +
> +	ret = dwc_pcie_pmu_read_dword(pcie_info, DWC_PCIE_EVENT_CNT_CTRL, &val);
> +	if (ret) {
> +		pci_err(pcie_info->pdev, "PCIe read fail\n");
> +		return ret;
> +	}
> +
> +	val &= ~(DWC_PCIE__CNT_ENABLE_MASK);

Superfluous parens.

> +static int dwc_pcie_pmu_base_time_add_prepare(struct dwc_pcie_info_table
> +					      *pcie_info, u32 event_id)
> +{
> +	u32 ret;
> +	u32 val;
> +
> +	ret = dwc_pcie_pmu_read_dword(pcie_info,
> +				      DWC_PCIE_TIME_BASED_ANALYSIS_CTRL, &val);
> +	if (ret) {
> +		pci_err(pcie_info->pdev, "PCIe read fail\n");
> +		return ret;
> +	}
> +
> +	val &= ~DWC_PCIE__TIME_BASED_REPORT_SELECT_MASK;
> +	val |= event_id << DWC_PCIE__TIME_BASED_REPORT_SELECT_SHIFT;
> +	val &= ~DWC_PCIE__TIME_BASED_DURATION_SELECT;
> +
> +	/*
> +	 * TIME_BASED_ANALYSIS_DATA_REG is a 64 bit register, we can safely
> +	 * use it with any manually controllered duration.

s/controllered/controlled/ ?  Not sure what this means.  Maybe that
64 bits is wide enough you don't need to worry about rollover?

> +static struct dwc_pcie_info_table *pmu_to_pcie_info(struct pmu *pmu)
> +{
> +	struct dwc_pcie_info_table *pcie_info;
> +	struct dwc_pcie_pmu *pcie_pmu = to_pcie_pmu(pmu);
> +
> +	pcie_info = container_of(pcie_pmu, struct dwc_pcie_info_table, pcie_pmu);
> +	if (pcie_info == NULL)
> +		pci_err(pcie_info->pdev, "Can't get pcie info\n");

It shouldn't be possible to get here for a pmu with no pcie_info, and
callers don't check for a NULL pointer return value before
dereferencing it, so I guess all this adds is an error message before
a NULL pointer oops?  Not sure the code clutter is worth it.

> +	return pcie_info;
> +}

> +static int dwc_pcie_pmu_event_init(struct perf_event *event)
> +{
> +	struct hw_perf_event *hwc = &event->hw;
> +	struct dwc_pcie_pmu *pcie_pmu = to_pcie_pmu(event->pmu);
> +	struct perf_event *sibling;
> +
> +	if (event->attr.type != event->pmu->type)
> +		return -ENOENT;
> +
> +	if (hwc->sample_period) {
> +		dev_dbg(pcie_pmu->dev, "Sampling not supported\n");
> +		return -EOPNOTSUPP;
> +	}
> +
> +	if (event->cpu < 0) {
> +		dev_dbg(pcie_pmu->dev, "Per-task mode not supported\n");
> +		return -EOPNOTSUPP;
> +	}
> +
> +	event->cpu = pcie_pmu->on_cpu;
> +
> +	if (event->group_leader != event &&
> +	    !is_software_event(event->group_leader)) {
> +		dev_dbg(pcie_pmu->dev, "Drive way only allow one event!\n");

"Drive way"?  -ENOPARSE for me :)

> +		return -EINVAL;
> +	}
> +
> +	for_each_sibling_event(sibling, event->group_leader) {
> +		if (sibling != event && !is_software_event(sibling)) {
> +			dev_dbg(pcie_pmu->dev, "Drive way event not allowed!\n");
> +			return -EINVAL;
> +		}
> +	}

> +static void dwc_pcie_pmu_set_period(struct hw_perf_event *hwc)
> +{
> +	u64 new = 0;

Superfluous variable.

> +	local64_set(&hwc->prev_count, new);
> +}

> +static int __dwc_pcie_pmu_probe(struct dwc_pcie_pmu_priv *priv,
> +				struct dwc_pcie_info_table *pcie_info)
> +{
> +	int ret;
> +	char *name;
> +	struct dwc_pcie_pmu *pcie_pmu;
> +	struct device *dev;
> +
> +	if (!pcie_info || !pcie_info->pdev) {
> +		pci_err(pcie_info->pdev, "Input parameter is invalid\n");

There are a lot of "Input parameter is invalid" messages.  If somebody
sees that, there's no hint about which one to look at.  Messages that
are constant strings are usually a hint that they could include more
information.

> +static int dwc_pcie_pmu_probe(struct platform_device *pdev)
> +{
> +	int ret = 0;
> +	int pcie_index;
> +	struct dwc_pcie_pmu_priv *priv;
> +
> +	priv = devm_kzalloc(&pdev->dev, sizeof(*priv), GFP_KERNEL);
> +	if (!priv)
> +		return -ENOMEM;
> +	priv->dev = &pdev->dev;
> +	platform_set_drvdata(pdev, priv);
> +
> +	/* If PMU is not support on current platform, keep slient */

s/not support/not supported/
s/slient/silent/

Bjorn