Re: [PATCH 08/12] dt-bindings: pinctrl: qcom,sm8250-lpass-lpi: add bias-bus-hold and input-enable

[Krzysztof Kozlowski]

On 23/09/2022 11:31, Krzysztof Kozlowski wrote:
> On Thu, 22 Sep 2022 21:56:47 +0200, Krzysztof Kozlowski wrote:
>> The existing SC7280 LPASS pin controller nodes use bias-bus-hold and
>> input-enable, so allow them.  Squash also blank lines for readability.
>>
>> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
>> ---
>>  .../bindings/pinctrl/qcom,sm8250-lpass-lpi-pinctrl.yaml     | 6 ++----
>>  1 file changed, 2 insertions(+), 4 deletions(-)
>>
> 
> Running 'make dtbs_check' with the schema in this patch gives the
> following warnings. Consider if they are expected or the schema is
> incorrect. These may not be new warnings.
> 
> Note that it is not yet a requirement to have 0 warnings for dtbs_check.
> This will change in the future.
> 
> Full log is available here: https://patchwork.ozlabs.org/patch/1681325
> 
> 
> pinctrl@33c0000: 'dmic01-active-pins', 'dmic01-sleep-pins', 'rx_swr-active-pins', 'tx_swr-active-pins', 'tx_swr-sleep-pins', 'wsa-swr-active-pins', 'wsa-swr-sleep-pins' do not match any of the regexes: '-state$', 'pinctrl-[0-9]+'

This is being fixed in next DTS patches. I'll reorganize them if there
is going to be a resubmit.

Best regards,
Krzysztof