[PATCH 2/3] arm64: dts: qcom: msm8916-samsung-a2015: fix polarity of "enable" line of NFC chip

[Dmitry Torokhov]

According to s3fwrn5 driver code the "enable" GPIO line is driven "high"
when chip is not in use (mode is S3FWRN5_MODE_COLD), and is driven "low"
when chip is in use.

s3fwrn5_phy_power_ctrl():

	...
	gpio_set_value(phy->gpio_en, 1);
	...
	if (mode != S3FWRN5_MODE_COLD) {
		msleep(S3FWRN5_EN_WAIT_TIME);
		gpio_set_value(phy->gpio_en, 0);
		msleep(S3FWRN5_EN_WAIT_TIME);
	}

Therefore the line described by "en-gpios" property should be annotated
as "active low".

The wakeup gpio appears to have correct polarity (active high).

Signed-off-by: Dmitry Torokhov <dmitry.torokhov@xxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi b/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi
index 3255bd3fcb55..5f7cec347a4f 100644
--- a/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8916-samsung-a2015-common.dtsi
@@ -144,7 +144,7 @@ nfc@27 {
 			interrupt-parent = <&msmgpio>;
 			interrupts = <21 IRQ_TYPE_EDGE_RISING>;
 
-			en-gpios = <&msmgpio 20 GPIO_ACTIVE_HIGH>;
+			en-gpios = <&msmgpio 20 GPIO_ACTIVE_LOW>;
 			wake-gpios = <&msmgpio 49 GPIO_ACTIVE_HIGH>;
 
 			clocks = <&rpmcc RPM_SMD_BB_CLK2_PIN>;
-- 
2.38.0.rc1.362.ged0d419d3c-goog