Re: [PATCH v5 1/3] drm/msm/dp: cleared DP_DOWNSPREAD_CTRL register before start link training

[Abhinav Kumar]

On 9/12/2022 12:25 PM, Dmitry Baryshkov wrote:
> On 12/09/2022 22:21, Kuogee Hsieh wrote:
> > On 9/12/2022 11:39 AM, Dmitry Baryshkov wrote:
> > > On 12/09/2022 19:23, Kuogee Hsieh wrote:
> > > > DOWNSPREAD_CTRL (0x107) shall be cleared to 0 upon power-on reset or an
> > > > upstream device disconnect. This patch will enforce this rule by always
> > > > cleared DOWNSPREAD_CTRL register to 0 before start link training. At 
> > > > rare
> > > > case that DP MSA timing parameters may be mis-interpreted by the sink
> > > > which causes audio sampling rate be calculated wrongly and cause audio
> > > > did not work at sink if DOWNSPREAD_CTRL register is not cleared to 0.
> > > >
> > > > Changes in v2:
> > > > 1) fix spelling at commit text
> > > > 2) merge ssc variable into encoding[0]
> > > >
> > > > Changes in v3:
> > > > -- correct spelling of DOWNSPREAD_CTRL
> > > > -- replace err with len of ssize_t
> > > >
> > > > Changes in v4:
> > > > -- split into 2 patches
> > > >
> > > > Fixes: 154b5a7da0fd ("drm/msm/dp: add displayPort driver support")

Fixes tag is wrong here. It should be:

Fixes: c943b4948b58 ("drm/msm/dp: add displayPort driver support")

> > > > Signed-off-by: Kuogee Hsieh <quic_khsieh@xxxxxxxxxxx>
> > > > ---
> > > >   drivers/gpu/drm/msm/dp/dp_ctrl.c | 13 +++++--------
> > > >   1 file changed, 5 insertions(+), 8 deletions(-)
> > > >
> > > > diff --git a/drivers/gpu/drm/msm/dp/dp_ctrl.c 
> > > > b/drivers/gpu/drm/msm/dp/dp_ctrl.c
> > > > index ab6aa13..2c74c59 100644
> > > > --- a/drivers/gpu/drm/msm/dp/dp_ctrl.c
> > > > +++ b/drivers/gpu/drm/msm/dp/dp_ctrl.c
> > > > @@ -1245,8 +1245,7 @@ static int dp_ctrl_link_train(struct 
> > > > dp_ctrl_private *ctrl,
> > > >   {
> > > >       int ret = 0;
> > > >       const u8 *dpcd = ctrl->panel->dpcd;
> > > > -    u8 encoding = DP_SET_ANSI_8B10B;
> > > > -    u8 ssc;
> > > > +    u8 encoding[] = { 0, DP_SET_ANSI_8B10B };
> > > >       u8 assr;
> > > >       struct dp_link_info link_info = {0};
> > > >   @@ -1258,13 +1257,11 @@ static int dp_ctrl_link_train(struct 
> > > > dp_ctrl_private *ctrl,
> > > >         dp_aux_link_configure(ctrl->aux, &link_info);
> > > >   -    if (drm_dp_max_downspread(dpcd)) {
> > > > -        ssc = DP_SPREAD_AMP_0_5;
> > > > -        drm_dp_dpcd_write(ctrl->aux, DP_DOWNSPREAD_CTRL, &ssc, 1);
> > > > -    }
> > > > +    if (drm_dp_max_downspread(dpcd))
> > > > +        encoding[0] |= DP_SPREAD_AMP_0_5;
> > >
> > > It would be simpler to call drm_dp_dpcd_write(ssc, 
> > > DP_DOWNSPREAD_CTRL, 1) unconditionally here. You won't have to change 
> > > the encoding/DP_MAIN_LINK_CHANNEL_CODING_SET/etc.
> >
> > The difference is one write with 2 bytes against two writes with one 
> > byte each.
> >
> > I think it is more efficient to combine two bytes into one write since 
> > these two bytes are consecutive address.
>
> I probably wouldn't do so, nevertheless:
>
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
>
> > > >   -    drm_dp_dpcd_write(ctrl->aux, DP_MAIN_LINK_CHANNEL_CODING_SET,
> > > > -                &encoding, 1);
> > > > +    /* config DOWNSPREAD_CTRL and MAIN_LINK_CHANNEL_CODING_SET */
> > > > +    drm_dp_dpcd_write(ctrl->aux, DP_DOWNSPREAD_CTRL, encoding, 2);
> > > >         if (drm_dp_alternate_scrambler_reset_cap(dpcd)) {
> > > >           assr = DP_ALTERNATE_SCRAMBLER_RESET_ENABLE;