[PATCH v1 1/2] dt-bindings:iio:adc: add documentation for TI LMP92064 controller

[Leonard Göhrs]

Add binding documentation for the TI LMP92064 dual channel SPI ADC.

Signed-off-by: Leonard Göhrs <l.goehrs@xxxxxxxxxxxxxx>
---
 .../bindings/iio/adc/ti,lmp92064.yaml         | 60 +++++++++++++++++++
 1 file changed, 60 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/iio/adc/ti,lmp92064.yaml

diff --git a/Documentation/devicetree/bindings/iio/adc/ti,lmp92064.yaml b/Documentation/devicetree/bindings/iio/adc/ti,lmp92064.yaml
new file mode 100644
index 0000000000000..b7b5761baa108
--- /dev/null
+++ b/Documentation/devicetree/bindings/iio/adc/ti,lmp92064.yaml
@@ -0,0 +1,60 @@
+# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/iio/adc/ti,lmp92064.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Texas Instruments LMP92064 Precision Current and Voltage Sensor.
+
+maintainers:
+  - Leonard Göhrs <l.goehrs@xxxxxxxxxxxxxx>
+
+description: |
+  The LMP92064 is a two channel ADC intended for combined voltage and current
+  measurements.
+
+  The device contains two ADCs to allow simultaneous sampling of voltage and
+  current and thus of instantanious power consumption.
+
+properties:
+  compatible:
+    enum:
+      - ti,lmp92064
+
+  reg:
+    maxItems: 1
+
+  spi-max-frequency: true
+
+  shunt-resistor:
+    description: |
+      Value of the shunt resistor (in µΩ) connected between INCP and INCN,
+      across which current is measured. Used to provide correct scaling of the
+      raw adc measurement.
+
+  reset-gpios:
+    maxItems: 1
+
+required:
+  - compatible
+  - reg
+  - shunt-resistor
+
+additionalProperties: false
+
+examples:
+  - |
+    #include <dt-bindings/gpio/gpio.h>
+    spi {
+        #address-cells = <1>;
+        #size-cells = <0>;
+
+        adc@0 {
+            compatible = "ti,lmp92064";
+            reg = <0>;
+            spi-max-frequency = <1000000>;
+            shunt-resistor = <15000>;
+            reset-gpios = <&gpio1 16 GPIO_ACTIVE_HIGH>;
+        };
+    };
+...
-- 
2.30.2