[PATCH V3 1/4] ACPI / PCI: fix LPIC irq model default PCI IRQ polarity

[Jianmin Lv]

On LoongArch ACPI based systems, the irq trigger type of PCI devices
is high level, so high level triggered type is required to pass
to acpi_register_gsi when create irq mapping for PCI devices.

Signed-off-by: Jianmin Lv <lvjianmin@xxxxxxxxxxx>
---
 drivers/acpi/pci_irq.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/acpi/pci_irq.c b/drivers/acpi/pci_irq.c
index 08e15774fb9f..ff30ceca2203 100644
--- a/drivers/acpi/pci_irq.c
+++ b/drivers/acpi/pci_irq.c
@@ -387,13 +387,15 @@ int acpi_pci_irq_enable(struct pci_dev *dev)
 	u8 pin;
 	int triggering = ACPI_LEVEL_SENSITIVE;
 	/*
-	 * On ARM systems with the GIC interrupt model, level interrupts
+	 * On ARM systems with the GIC interrupt model, or LoongArch
+	 * systems with the LPIC interrupt model, level interrupts
 	 * are always polarity high by specification; PCI legacy
 	 * IRQs lines are inverted before reaching the interrupt
 	 * controller and must therefore be considered active high
 	 * as default.
 	 */
-	int polarity = acpi_irq_model == ACPI_IRQ_MODEL_GIC ?
+	int polarity = acpi_irq_model == ACPI_IRQ_MODEL_GIC ||
+		       acpi_irq_model == ACPI_IRQ_MODEL_LPIC ?
 				      ACPI_ACTIVE_HIGH : ACPI_ACTIVE_LOW;
 	char *link = NULL;
 	char link_desc[16];
-- 
2.31.1