Re: [PATCH v2 2/6] arm64: dts: qcom: sdm845-db845c: correct SPI2 pins drive strength

[Doug Anderson]

Hi,

On Mon, Oct 10, 2022 at 4:46 AM Krzysztof Kozlowski
<krzysztof.kozlowski@xxxxxxxxxx> wrote:
>
> The pin configuration (done with generic pin controller helpers and
> as expressed by bindings) requires children nodes with either:
> 1. "pins" property and the actual configuration,
> 2. another set of nodes with above point.
>
> The qup_spi2_default pin configuration uses alreaady the second method
> with a "pinmux" child, so configure drive-strength similarly in
> "pinconf".  Otherwise the PIN drive strength would not be applied.
>
> Fixes: 8d23a0040475 ("arm64: dts: qcom: db845c: add Low speed expansion i2c and spi nodes")
> Cc: <stable@xxxxxxxxxxxxxxx>
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
>
> ---
>
> Not tested on hardware.
>
> Changes since v1:
> 1. Put it under pinconf instead of pinmux, as suggested by Doug.

I notice that there are other two patches in the series that put the
configuration info under the mux node. ;-) They are with SoCs / boards
that I wasn't really involved in and so I won't do anything to block
them from landing but, as per my replies to v1 it's not my favorite...

In any case, this patch here looks great to me. Thanks! Looking
forward to seeing these converted over to the scheme that your sc7180
patches used.

Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>