[PATCH v2 1/3] arm64: dts: qcom: sc7180-trogdor-homestar: fully configure secondary I2S pins

[Krzysztof Kozlowski]

The Trogdor Homestar DTSI adds additional GPIO52 pin to secondary I2S pins
("sec_mi2s_active") and configures it to "mi2s_1" function.

The Trogdor DTSI (which is included by Homestar) configures drive
strength and bias for all "sec_mi2s_active" pins, thus the intention was
to apply this configuration also to GPIO52 on Homestar.

Reported-by: Doug Anderson <dianders@xxxxxxxxxxxx>
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>

---

Changes since v1:
1. New patch

Not tested on hardware.

Cc: Doug Anderson <dianders@xxxxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi | 6 ++++++
 1 file changed, 6 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi b/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
index 1bd6c7dcd9e9..bfab67f4a7c9 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
@@ -194,6 +194,12 @@ pinmux {
 		pins = "gpio49", "gpio50", "gpio51", "gpio52";
 		function = "mi2s_1";
 	};
+
+	pinconf {
+		pins = "gpio49", "gpio50", "gpio51", "gpio52";
+		drive-strength = <2>;
+		bias-pull-down;
+	};
 };
 
 &ts_reset_l {
-- 
2.34.1