Re: [PATCH 07/10] crypto: Use ARCH_DMA_MINALIGN instead of ARCH_KMALLOC_MINALIGN

[Saravana Kannan]

On Thu, Oct 13, 2022 at 9:57 AM Catalin Marinas <catalin.marinas@xxxxxxx> wrote:
>
> On Wed, Oct 12, 2022 at 10:45:45AM -0700, Isaac Manjarres wrote:
> > On Fri, Sep 30, 2022 at 07:32:50PM +0100, Catalin Marinas wrote:
> > > I started refreshing the series but I got stuck on having to do bouncing
> > > for small buffers even if when they go through the iommu (and I don't
> > > have the set up to test it yet).
> >
> > For devices that go through the IOMMU, are you planning on adding
> > similar logic as you did in the direct-DMA path to bounce the buffer
> > prior to calling into whatever DMA ops are registered for the device?
>
> Yes.
>
> > Also, there are devices with ARM64 CPUs that disable SWIOTLB usage because
> > none of the peripherals that they engage in DMA with need bounce buffering,
> > and also to reclaim the default 64 MB of memory that SWIOTLB uses. With
> > this approach, SWIOTLB usage will become mandatory if those devices need
> > to perform non-coherent DMA transactions that may not necessarily be DMA
> > aligned (e.g. small buffers), correct?
>
> Correct. I've been thinking about this and a way around is to combine
> the original series (dynamic kmalloc_minalign) with the new one so that
> the arch code can lower the minimum alignment either to 8 if swiotlb is
> available (usually in server space with more RAM) or the cache line size
> if there is no bounce buffer.
>
> > If so, would there be concerns that the memory savings we get back from
> > reducing the memory footprint of kmalloc might be defeated by how much
> > memory is needed for bounce buffering?
>
> It's not necessarily about the saved memory but also locality of the
> small buffer allocations, less cache and TLB pressure.

Part of the pushback we get when we try to move some of the Android
ecosystem from 32-bit to 64-bit is the memory usage increase. So,
while the main goal might not be memory savings, it'll be good to keep
that in mind too. I'd definitely not want this patch series to make
things worse. Ideally, it'd make things better. 10MB is considered a
lot on some of the super low speced devices.

> > I understand that we can use the
> > "swiotlb=num_slabs" command line parameter to minimize the amount of
> > memory allocated for bounce buffering. If this is the only way to
> > minimize this impact, how much memory would you recommend to allocate
> > for bounce buffering on a system that will only use bounce buffers for
> > non-DMA-aligned buffers?
>
> It's hard to tell, it would need to be guessed by trial and error on
> specific hardware if you want to lower it. Another issue is that IIRC
> the swiotlb is allocated in 2K slots, so you may need a lot more bounce
> buffers than the actual memory allocated.
>
> I wonder whether swiotlb is actually the best option for bouncing
> unaligned buffers. We could use something like mempool_alloc() instead
> if we stick to small buffers rather than any (even large) buffer that's
> not aligned to a cache line. Or just go for kmem_cache_alloc() directly.
> A downside is that we may need GFP_ATOMIC for such allocations, so
> higher risk of failure.

Yeah, a temporary kmem_cache_alloc() to bounce buffers off of feels
like a better idea than swiotlb. Especially for small allocations (say
8 byte allocations) that might have gone into the kmem-cache-64 if we
hadn't dropped KMALLOC_MIN_ALIGN to 8.

-Saravana