Re: [PATCH] xhci: print warning when HCE was set

[Mathias Nyman]

On 14.10.2022 6.12, liulongfang wrote:
> On 2022/9/26 15:58, Mathias Nyman wrote:
> > On 24.9.2022 5.35, liulongfang wrote:
> > > On 2022/9/22 21:01, Mathias Nyman Wrote:
> > > > Hi
> > > >
> > > > On 15.9.2022 4.11, Longfang Liu wrote:
> > > > > When HCE(Host Controller Error) is set, it means that the xhci hardware
> > > > > controller has an error at this time, but the current xhci driver
> > > > > software does not log this event.
> > > > >
> > > > > By adding an HCE event detection in the xhci interrupt processing
> > > > > interface, a warning log is output to the system, which is convenient
> > > > > for system device status tracking.
> > > >
> > > > xHC should cease all activity when it sets HCE, and is probably not
> > > > generating interrupts anymore.
> > > >
> > > > Would probably be more useful to check for HCE at timeouts than in the
> > > > interrupt handler.
> > >
> > > Which function of the driver code is this timeout in?
> >
> > xhci_handle_command_timeout() will usually trigger at some point,
>
> Because this HCE error is reported in the form of an interrupt signal, it is more
> concise to put it in xhci_irq() than in xhci_handle_command_timeout().

Patch was added to queue after you reported your xHC hardware triggers interrupts when HCE is set.
I'll send it forward after 6.1-rc1

xHCI specification still indicate HCE might not trigger interrupts:
 
Section 4.24.1 -Internal Errors
...
"Software should implement an algorithm for checking the HCE flag if the xHC is
not responding."

Thanks
-Mathias