Re: [PATCH 00/10] Add support for USB on STM32MP13

[Fabrice Gasnier]

On 10/14/22 11:26, Fabrice Gasnier wrote:
> Add support for USBPHYC, USB Host and USB OTG on STM32MP13.
> Enable all these interfaces on STM32MP135F-DK board.
> Enable the STM32G0 UCSI driver as module.
> Dependency on PWR and PMIC regulator is tempoarily managed by using
> fixed regulators (resp in the SoC dtsi and the board dts files).
> The USB support is functional when these regulators gets enabled at
> boot time before entering the kernel.

Hi,

Please discard this series. Generic node names recommendation has been
missed.
I'll send a V2.

Sorry for the noise.
Best Regards,
Fabrice

> 
> Amelie Delaunay (5):
>   ARM: dts: stm32: add USBPHYC and dual USB HS PHY support on stm32mp131
>   ARM: dts: stm32: add UBSH EHCI and OHCI support on stm32mp131
>   ARM: dts: stm32: add USB OTG HS support on stm32mp131
>   ARM: dts: stm32: enable USB HS phys on stm32mp135f-dk
>   ARM: dts: stm32: enable USB Host EHCI on stm32mp135f-dk
> 
> Fabrice Gasnier (5):
>   ARM: dts: stm32: add PWR fixed regulators on stm32mp131
>   ARM: dts: stm32: add fixed regulators to support usb on stm32mp135f-dk
>   ARM: dts: stm32: add pins for stm32g0 typec controller on stm32mp13
>   ARM: dts: stm32: enable USB OTG in dual role mode on stm32mp135f-dk
>   ARM: multi_v7_defconfig: enable Type-C UCSI and STM32G0 as modules
> 
>  arch/arm/boot/dts/stm32mp13-pinctrl.dtsi |  7 ++
>  arch/arm/boot/dts/stm32mp131.dtsi        | 81 ++++++++++++++++++++
>  arch/arm/boot/dts/stm32mp135f-dk.dts     | 95 ++++++++++++++++++++++++
>  arch/arm/configs/multi_v7_defconfig      |  2 +
>  4 files changed, 185 insertions(+)
>