Re: [PATCH 3/3] iio: temperature: ltc2983: support more parts

[Jonathan Cameron]

On Fri, 14 Oct 2022 15:37:24 +0300
Cosmin Tanislav <demonsingur@xxxxxxxxx> wrote:

> From: Cosmin Tanislav <cosmin.tanislav@xxxxxxxxxx>
> 
> Add support for the following parts:
>  * LTC2984
>  * LTC2986
>  * LTM2985
> 
> The LTC2984 is a variant of the LTC2983 with EEPROM.
> The LTC2986 is a variant of the LTC2983 with only 10 channels,
> EEPROM and support for active analog temperature sensors.
> The LTM2985 is software-compatible with the LTC2986.
> 
> Signed-off-by: Cosmin Tanislav <cosmin.tanislav@xxxxxxxxxx>

...

Hi Cosmin,

Looks good except, I think we are still in the position that
regmap for spi doesn't guarantee to bounce buffer the bulk accesses
(last time I checked it actually did do so, but before that it didn't
and there are obvious optimizations to take it back to not doing so -
IRC Mark Brown's answer was we shouldn't rely on it..)

Anyhow, the existing driver has instances of this so its no worse
but we should really clean those up.

Jonathan


>  
> +static int ltc2983_eeprom_cmd(struct ltc2983_data *st, unsigned int cmd,
> +			      unsigned int wait_time, unsigned int status_reg,
> +			      unsigned long status_fail_mask)
> +{
> +	__be32 bval = cpu_to_be32(LTC2983_EEPROM_KEY);
> +	unsigned long time;
> +	unsigned int val;
> +	int ret;
> +
> +	ret = regmap_bulk_write(st->regmap, LTC2983_EEPROM_KEY_REG, &bval,
> +				sizeof(bval));

SPI device and I was clearly dozing on existing driver but normally
we avoid assuming that regmap will always use a bounce buffer for bulk
accessors. Hence this should be a DMA safe buffer.


> +	if (ret)
> +		return ret;
> +
> +	reinit_completion(&st->completion);
> +
> +	ret = regmap_write(st->regmap, LTC2983_STATUS_REG,
> +			   LTC2983_STATUS_START(true) | cmd);
> +	if (ret)
> +		return ret;
> +
> +	time = wait_for_completion_timeout(&st->completion,
> +					   msecs_to_jiffies(wait_time));
> +	if (!time) {
> +		dev_err(&st->spi->dev, "EEPROM command timed out\n");
> +		return -ETIMEDOUT;
> +	}
> +
> +	ret = regmap_read(st->regmap, status_reg, &val);
> +	if (ret)
> +		return ret;
> +
> +	if (val & status_fail_mask) {
> +		dev_err(&st->spi->dev, "EEPROM command failed: 0x%02X\n", val);
> +		return -EINVAL;
> +	}
> +
> +	return 0;
> +}
> +