Re: [PATCH v2 1/3] arm64: dts: qcom: sc7180-trogdor-homestar: fully configure secondary I2S pins

[Doug Anderson]

Hi,

On Thu, Oct 13, 2022 at 11:49 AM Krzysztof Kozlowski
<krzysztof.kozlowski@xxxxxxxxxx> wrote:
>
> The Trogdor Homestar DTSI adds additional GPIO52 pin to secondary I2S pins
> ("sec_mi2s_active") and configures it to "mi2s_1" function.
>
> The Trogdor DTSI (which is included by Homestar) configures drive
> strength and bias for all "sec_mi2s_active" pins, thus the intention was
> to apply this configuration also to GPIO52 on Homestar.
>
> Reported-by: Doug Anderson <dianders@xxxxxxxxxxxx>
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>

Fixes: be0416a3f917 ("arm64: dts: qcom: Add sc7180-trogdor-homestar")

> ---
>
> Changes since v1:
> 1. New patch
>
> Not tested on hardware.
>
> Cc: Doug Anderson <dianders@xxxxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi | 6 ++++++
>  1 file changed, 6 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi b/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
> index 1bd6c7dcd9e9..bfab67f4a7c9 100644
> --- a/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
> +++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
> @@ -194,6 +194,12 @@ pinmux {
>                 pins = "gpio49", "gpio50", "gpio51", "gpio52";
>                 function = "mi2s_1";
>         };
> +
> +       pinconf {
> +               pins = "gpio49", "gpio50", "gpio51", "gpio52";
> +               drive-strength = <2>;
> +               bias-pull-down;
> +       };

Personally I wouldn't have replicated the "drive-strength" and
"bias-pull-down" here (nor would I have replicated the "function =
"mi2s_1"" in the node above but I didn't notice it before). ...but it
doesn't really hurt, the resulting dtb (after combining all includes)
isn't changed, and you've about to clean this up in your next patch.

Thus:

Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx>