Re: [PATCH v5 2/3] arm64: dts: qcom: sa8295p: move common nodes to dtsi

[Bjorn Andersson]

On Mon, Oct 03, 2022 at 06:24:43PM +0530, Parikshit Pareek wrote:
> There are many ADP boards with lot of common features. Move common
> nodes, like remoteproc, regulators etc. to sa8540p-adp.dtsi file.
> This will be base for many ADP boards to be introduced in near future.
> Common nodes are like clocks, remoteproc, regulators etc.
> 
> The differences between the sa8295 ADP board, and sa8540p ADP board
> (Qdrive-3), with respect to device/connector-interface, are as following:
> 

After reviewing the qdrive3 schematics I do think that describing the
two ADP boards as a delta between them is not going to serve us well in
the long run - they are quite different.

So let's just create a new dts for the qdrive3, and if there are
additional boards they will either again be sufficiently different or we
could turn these into dtsi files and inherit from there.

Regards,
Bjorn