[PATCH net] net: phy: Avoid WARN_ON for PHY_NOLINK during resuming

[Kunihiko Hayashi]

When resuming from sleep, if there is a time lag from link-down to link-up
due to auto-negotiation, the phy status has been still PHY_NOLINK, so
WARN_ON dump occurs in mdio_bus_phy_resume(). For example, UniPhier AVE
ethernet takes about a few seconds to link up after resuming.

To avoid this issue, should remove PHY_NOLINK the WARN_ON conditions.

Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@xxxxxxxxxxxxx>
---
 drivers/net/phy/phy_device.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 57849ac0384e..c647d027bb5d 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -318,12 +318,12 @@ static __maybe_unused int mdio_bus_phy_resume(struct device *dev)
 	phydev->suspended_by_mdio_bus = 0;
 
 	/* If we managed to get here with the PHY state machine in a state
-	 * neither PHY_HALTED, PHY_READY nor PHY_UP, this is an indication
-	 * that something went wrong and we should most likely be using
-	 * MAC managed PM, but we are not.
+	 * neither PHY_HALTED, PHY_READY, PHY_UP nor PHY_NOLINK, this is an
+	 * indication that something went wrong and we should most likely
+	 * be using MAC managed PM, but we are not.
 	 */
 	WARN_ON(phydev->state != PHY_HALTED && phydev->state != PHY_READY &&
-		phydev->state != PHY_UP);
+		phydev->state != PHY_UP && phydev->state != PHY_NOLINK);
 
 	ret = phy_init_hw(phydev);
 	if (ret < 0)
-- 
2.25.1