Re: [PATCH v4 1/2] dt-bindings: mtd: marvell-nand: Convert to YAML DT scheme

[Krzysztof Kozlowski]

On 25/10/2022 06:17, Vadym Kochan wrote:
> Switch the DT binding to a YAML schema to enable the DT validation.
> 
> Dropped deprecated compatibles and properties described in txt file.
> 
> Signed-off-by: Vadym Kochan <vadym.kochan@xxxxxxxxxxx>
> ---
> 
> v4:
>    1) Remove "label" and "partitions" properties

I think you did not read the feedback.


(...)

> +
> +  marvell,system-controller:
> +    $ref: /schemas/types.yaml#/definitions/phandle
> +    description: Syscon node that handles NAND controller related registers
> +
> +patternProperties:
> +  "^nand@[0-3]$":
> +    type: object
> +    properties:
> +      reg:
> +        minimum: 0
> +        maximum: 3
> +
> +      nand-rb:
> +        minimum: 0
> +        maximum: 1
> +
> +      nand-ecc-strength:
> +        enum: [1, 4, 8]
> +
> +      nand-on-flash-bbt: true
> +
> +      nand-ecc-mode: true
> +
> +      nand-ecc-algo:
> +        description: |
> +          This property is essentially useful when not using hardware ECC.
> +          Howerver, it may be added when using hardware ECC for clarification
> +          but will be ignored by the driver because ECC mode is chosen depending
> +          on the page size and the strength required by the NAND chip.
> +          This value may be overwritten with nand-ecc-strength property.
> +
> +      nand-ecc-step-size:
> +        description: |
> +          Marvell's NAND flash controller does use fixed strength
> +          (1-bit for Hamming, 16-bit for BCH), so the actual step size
> +          will shrink or grow in order to fit the required strength.
> +          Step sizes are not completely random for all and follow certain
> +          patterns described in AN-379, "Marvell SoC NFC ECC".
> +
> +      marvell,nand-keep-config:
> +        description: |
> +          Orders the driver not to take the timings from the core and
> +          leaving them completely untouched. Bootloader timings will then
> +          be used.
> +        $ref: /schemas/types.yaml#/definitions/flag
> +
> +      marvell,nand-enable-arbiter:
> +        description: |
> +          To enable the arbiter, all boards blindly used it,
> +          this bit was set by the bootloader for many boards and even if
> +          it is marked reserved in several datasheets, it might be needed to set
> +          it (otherwise it is harmless) so whether or not this property is set,
> +          the bit is selected by the driver.
> +        $ref: /schemas/types.yaml#/definitions/flag
> +        deprecated: true
> +
> +    required:
> +      - reg
> +      - nand-rb

I have no clue why you are doing some random changes. Now you dropped
additionalProperties for nand@ about which no one asked you to drop.

No. It *must* be here.

Best regards,
Krzysztof