Re: [PATCH 10/15] scsi: ufs: ufs-qcom: Use bitfields where appropriate
From: Manivannan Sadhasivam
Date: Mon Oct 31 2022 - 10:50:24 EST
On Sun, Oct 30, 2022 at 12:58:57AM +0300, Dmitry Baryshkov wrote:
> On 29/10/2022 17:16, Manivannan Sadhasivam wrote:
> > Use bitfield macros where appropriate to simplify the driver.
> >
> > Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> > ---
> > drivers/ufs/host/ufs-qcom.h | 58 ++++++++++++++++---------------------
> > 1 file changed, 25 insertions(+), 33 deletions(-)
> >
>
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
>
> > diff --git a/drivers/ufs/host/ufs-qcom.h b/drivers/ufs/host/ufs-qcom.h
> > index 44466a395bb5..6cb0776456b3 100644
> > --- a/drivers/ufs/host/ufs-qcom.h
> > +++ b/drivers/ufs/host/ufs-qcom.h
> > @@ -17,12 +17,9 @@
> > #define DEFAULT_CLK_RATE_HZ 1000000
> > #define BUS_VECTOR_NAME_LEN 32
> > -#define UFS_HW_VER_MAJOR_SHFT (28)
> > -#define UFS_HW_VER_MAJOR_MASK (0x000F << UFS_HW_VER_MAJOR_SHFT)
> > -#define UFS_HW_VER_MINOR_SHFT (16)
> > -#define UFS_HW_VER_MINOR_MASK (0x0FFF << UFS_HW_VER_MINOR_SHFT)
> > -#define UFS_HW_VER_STEP_SHFT (0)
> > -#define UFS_HW_VER_STEP_MASK (0xFFFF << UFS_HW_VER_STEP_SHFT)
> > +#define UFS_HW_VER_MAJOR_MASK GENMASK(31, 28)
> > +#define UFS_HW_VER_MINOR_MASK GENMASK(27, 16)
> > +#define UFS_HW_VER_STEP_MASK GENMASK(15, 0)
> > /* vendor specific pre-defined parameters */
> > #define SLOW 1
> > @@ -76,24 +73,24 @@ enum {
> > #define UFS_CNTLR_3_x_x_VEN_REGS_OFFSET(x) (0x400 + x)
> > /* bit definitions for REG_UFS_CFG1 register */
> > -#define QUNIPRO_SEL 0x1
> > -#define UTP_DBG_RAMS_EN 0x20000
> > +#define QUNIPRO_SEL BIT(0)
> > +#define UTP_DBG_RAMS_EN BIT(17)
> > #define TEST_BUS_EN BIT(18)
> > #define TEST_BUS_SEL GENMASK(22, 19)
> > #define UFS_REG_TEST_BUS_EN BIT(30)
> > /* bit definitions for REG_UFS_CFG2 register */
> > -#define UAWM_HW_CGC_EN (1 << 0)
> > -#define UARM_HW_CGC_EN (1 << 1)
> > -#define TXUC_HW_CGC_EN (1 << 2)
> > -#define RXUC_HW_CGC_EN (1 << 3)
> > -#define DFC_HW_CGC_EN (1 << 4)
> > -#define TRLUT_HW_CGC_EN (1 << 5)
> > -#define TMRLUT_HW_CGC_EN (1 << 6)
> > -#define OCSC_HW_CGC_EN (1 << 7)
> > +#define UAWM_HW_CGC_EN BIT(0)
> > +#define UARM_HW_CGC_EN BIT(1)
> > +#define TXUC_HW_CGC_EN BIT(2)
> > +#define RXUC_HW_CGC_EN BIT(3)
> > +#define DFC_HW_CGC_EN BIT(4)
> > +#define TRLUT_HW_CGC_EN BIT(5)
> > +#define TMRLUT_HW_CGC_EN BIT(6)
> > +#define OCSC_HW_CGC_EN BIT(7)
> > /* bit definition for UFS_UFS_TEST_BUS_CTRL_n */
> > -#define TEST_BUS_SUB_SEL_MASK 0x1F /* All XXX_SEL fields are 5 bits wide */
> > +#define TEST_BUS_SUB_SEL_MASK GENMASK(4, 0) /* All XXX_SEL fields are 5 bits wide */
> > #define REG_UFS_CFG2_CGC_EN_ALL (UAWM_HW_CGC_EN | UARM_HW_CGC_EN |\
> > TXUC_HW_CGC_EN | RXUC_HW_CGC_EN |\
> > @@ -101,17 +98,12 @@ enum {
> > TMRLUT_HW_CGC_EN | OCSC_HW_CGC_EN)
> > /* bit offset */
> > -enum {
> > - OFFSET_UFS_PHY_SOFT_RESET = 1,
> > - OFFSET_CLK_NS_REG = 10,
> > -};
> > +#define OFFSET_CLK_NS_REG 0xa
> > /* bit masks */
> > -enum {
> > - MASK_UFS_PHY_SOFT_RESET = 0x2,
> > - MASK_TX_SYMBOL_CLK_1US_REG = 0x3FF,
> > - MASK_CLK_NS_REG = 0xFFFC00,
> > -};
> > +#define MASK_UFS_PHY_SOFT_RESET BIT(1)
> > +#define MASK_TX_SYMBOL_CLK_1US_REG GENMASK(9, 0)
> > +#define MASK_CLK_NS_REG GENMASK(23, 10)
> > /* QCOM UFS debug print bit mask */
> > #define UFS_QCOM_DBG_PRINT_REGS_EN BIT(0)
> > @@ -135,15 +127,15 @@ ufs_qcom_get_controller_revision(struct ufs_hba *hba,
> > {
> > u32 ver = ufshcd_readl(hba, REG_UFS_HW_VERSION);
> > - *major = (ver & UFS_HW_VER_MAJOR_MASK) >> UFS_HW_VER_MAJOR_SHFT;
> > - *minor = (ver & UFS_HW_VER_MINOR_MASK) >> UFS_HW_VER_MINOR_SHFT;
> > - *step = (ver & UFS_HW_VER_STEP_MASK) >> UFS_HW_VER_STEP_SHFT;
> > + *major = FIELD_GET(UFS_HW_VER_MAJOR_MASK, ver);
> > + *minor = FIELD_GET(UFS_HW_VER_MINOR_MASK, ver);
> > + *step = FIELD_GET(UFS_HW_VER_STEP_MASK, ver);
> > };
> > static inline void ufs_qcom_assert_reset(struct ufs_hba *hba)
> > {
> > - ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET,
> > - 1 << OFFSET_UFS_PHY_SOFT_RESET, REG_UFS_CFG1);
> > + ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET, FIELD_PREP(MASK_UFS_PHY_SOFT_RESET, 1),
>
> Nit: I'd just define the value too and use the defined name here.
>
> > + REG_UFS_CFG1);
> > /*
> > * Make sure assertion of ufs phy reset is written to
> > @@ -154,8 +146,8 @@ static inline void ufs_qcom_assert_reset(struct ufs_hba *hba)
> > static inline void ufs_qcom_deassert_reset(struct ufs_hba *hba)
> > {
> > - ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET,
> > - 0 << OFFSET_UFS_PHY_SOFT_RESET, REG_UFS_CFG1);
> > + ufshcd_rmwl(hba, MASK_UFS_PHY_SOFT_RESET, FIELD_PREP(MASK_UFS_PHY_SOFT_RESET, 0),
>
> Nit: FIELD_PREP is always 0.
>
I know but this make the code in sync with reset assert.
Thanks,
Mani
> > + REG_UFS_CFG1);
> > /*
> > * Make sure de-assertion of ufs phy reset is written to
>
> --
> With best wishes
> Dmitry
>
--
மணிவண்ணன் சதாசிவம்