Re: [PATCH 12/14] phy: qcom-qmp-combo: rename common-register pointers

[Dmitry Baryshkov]

On 14/11/2022 15:54, Johan Hovold wrote:
> On Sat, Nov 12, 2022 at 02:31:27PM +0300, Dmitry Baryshkov wrote:
> > On 11/11/2022 12:24, Johan Hovold wrote:
> > > The common registers are shared by the USB and DP parts of the PHY so
> > > drop the misleading "dp" prefix from the corresponding pointers.
> > >
> > > Note that the "DP" prefix could also be dropped from the corresponding
> > > defines, but leave that in place for now.
> > >
> > > Signed-off-by: Johan Hovold <johan+linaro@xxxxxxxxxx>
> > > ---
> > >    drivers/phy/qualcomm/phy-qcom-qmp-combo.c | 24 +++++++++++------------
> > >    1 file changed, 12 insertions(+), 12 deletions(-)
> >
> > Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> >
> > Note regarding the last phrase: I'd suggest leaving the DP prefix in
> > register names, it makes it easier to visually note & verify the
> > register block.
>
> My point is that "DP" was never part of the COM register block name. The
> confusion likely comes from the vendor driver naming these defines along
> the lines of
>
> 	USB3_DP_COM_POWER_DOWN_CTRL
>
> Here "USB3_DP" is the common prefix for all defines that apply to both
> "parts" of the PHY so the corresponding Linux define
>
> 	QPHY_V3_DP_COM_POWER_DOWN_CTRL
>
> should either include "USB3" or drop "DP".

My thought was that we already have too many _COM_ defines in the qmp 
headers. Having QPHY_Vn_COM_something would make it too easy to mix it 
with QSERDES_Vn_COM_foo. Thus I'd vote to leave DP_COM prefix in place. 
While it might be not fully accurate, it serves the point of identifying 
the register block.

> This becomes more apparent on SC8280XP where the corresponding define
> is:
>
> 	USB43DP_COM_POWER_DOWN_CTRL

I'd still use something like QPHY_V10_DP_COM_POWER_DOWN_CTRL here.

> Johan

--
With best wishes
Dmitry