Re: [PATCH v2 1/5] dt-bindings: pinctrl: Add StarFive JH7110 pinctrl definitions

[Jianlong Huang]

On Mon, 28 Nov 2022 09:32:45 +0100, Krzysztof Kozlowski wrote:
> On 28/11/2022 01:48, Jianlong Huang wrote:
> 
>>>>> +/* aon_iomux doen */
>>>>> +#define GPOEN_AON_PTC0_OE_N_4			2
>>>>> +#define GPOEN_AON_PTC0_OE_N_5			3
>>>>> +#define GPOEN_AON_PTC0_OE_N_6			4
>>>>> +#define GPOEN_AON_PTC0_OE_N_7			5
>>>>> +
>>>>
>>>> It looks like you add register constants to the bindings. Why? The
>>>> bindings are not the place to represent hardware programming model. Not
>>>> mentioning that there is no benefit in this.
>>>
>>> Also: this entire file should be dropped, but if it stays, you have to
>>> name it matching bindings or compatible (vendor,device.h).
>> 
>> Thanks your comments.
>> These macros are used to configure pinctrl in dts, so the file should stay,
> 
> Why they should stay? What's the reason? If it is not a constant used by
> driver, then register values should not be placed in the bindings, so
> drop it.
> 

Thanks.

These macros in binding header(example, DOUT, DOEN etc) will be used in DTS,
and driver will parse the DT for pinctrl configuration.

Example in dts:
uart0_pins: uart0-0 {
	tx-pins {
		pinmux = <GPIOMUX(5, GPOUT_SYS_UART0_TX, GPOEN_ENABLE, GPI_NONE)>;
		bias-disable;
		drive-strength = <12>;
		input-disable;
		input-schmitt-disable;
		slew-rate = <0>;
	};

	rx-pins {
		pinmux = <GPIOMUX(6, GPOUT_LOW, GPOEN_DISABLE, GPI_SYS_UART0_RX)>;
		bias-pull-up;
		drive-strength = <2>;
		input-enable;
		input-schmitt-enable;
		slew-rate = <0>;
	};
};


Best regards,
Jianlong Huang