Re: [PATCH v2 12/12] riscv: defconfig: Enable the Allwinner D1 platform and drivers

[Andrew Jones]

On Mon, Nov 28, 2022 at 09:17:38PM +0000, Conor Dooley wrote:
> On 28/11/2022 21:11, Heiko Stübner wrote:
> > Am Samstag, 26. November 2022, 17:40:11 CET schrieb Conor Dooley:
> >> On Fri, Nov 25, 2022 at 05:46:56PM -0600, Samuel Holland wrote:
> >>> Now that several D1-based boards are supported, enable the platform in
> >>> our defconfig. Build in the drivers which are necessary to boot, such as
> >>> the pinctrl, MMC, RTC (which provides critical clocks), SPI (for flash),
> >>> and watchdog (which may be left enabled by the bootloader).
> >>
> >> All of that looks good.
> >>
> >>> Other common
> >>> onboard peripherals are enabled as modules.
> >>
> >> This I am not sure about though. I'll leave that to Palmer since I'm
> >> pretty sure it was him that said it, but I thought the plan was only
> >> turning on stuff required to boot to a console & things that are
> >> generally useful rather than enabling modules for everyone's "random"
> >> drivers. Palmer?
> > 
> > Isn't the defconfig meant as a starting point to get working systems
> > with minimal config effort? At least that was always the way to go on arm
> > so far :-) .
> > 
> > So having boot-required drivers built-in with the rest enabled as modules
> > for supported boards will allow people to boot theirs without headaches.
> > 
> > Disabling unneeded drivers if you're starved for storage space in a special
> > project is always easier than hunting down all the drivers to enable for a
> > specific board. 
> 
> I wouldn't mind being able to turn on all the PolarFire SoC stuff and
> yeah, that would be the way that arm64 does it. But I do recall hearing
> that I should not turn stuff on this way, when I initially tried to
> turn stuff on via selects, got a nack and asked if I could do this instead.
> 
> But it may be that I misremember, which is why I appealed to the Higher
> Powers for clarification :)

FWIW, I don't worry too much about modules in defconfig because I always
immediately apply a 'LSMOD=$PWD/L localmodconfig' to it, where the L
file is an lsmod output which only includes modules I need.

Thanks,
drew

> 
> _______________________________________________
> linux-riscv mailing list
> linux-riscv@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-riscv