Re: [PATCH net v2 2/2] phy: aquantia: Determine rate adaptation support from registers

[Sean Anderson]

On 11/28/22 19:42, Russell King (Oracle) wrote:
> On Mon, Nov 28, 2022 at 07:21:56PM -0500, Sean Anderson wrote:
>> On 11/28/22 18:22, Russell King (Oracle) wrote:
>> > This doesn't make any sense. priv->supported_speeds is the set of speeds
>> > read from the PMAPMD. The only bits that are valid for this are the
>> > MDIO_PMA_SPEED_* definitions, but teh above switch makes use of the
>> > MDIO_PCS_SPEED_* definitions. To see why this is wrong, look at these
>> > two definitions:
>> > 
>> > #define MDIO_PMA_SPEED_10               0x0040  /* 10M capable */
>> > #define MDIO_PCS_SPEED_2_5G             0x0040  /* 2.5G capable */
>> > 
>> > Note that they are the same value, yet above, you're testing for bit 6
>> > being clear effectively for both 10M and 2.5G speeds. I suspect this
>> > is *not* what you want.
>> > 
>> > MDIO_PMA_SPEED_* are only valid for the PMAPMD MMD (MMD 1).
>> > MDIO_PCS_SPEED_* are only valid for the PCS MMD (MMD 3).
>> 
>> Ugh. I almost noticed this from the register naming...
>> 
>> Part of the problem is that all the defines are right next to each other
>> with no indication of what you just described.
> 
> That's because they all refer to the speed register which is at the same
> address, but for some reason the 802.3 committees decided to make the
> register bits mean different things depending on the MMD. That's why the
> definition states the MMD name in it.

Well, then it's really a different register per MMD (and therefore the
definitions should be better separated). Grouping them together implies
that they share bits, when they do not (except for the 10G bit).

> This is true of all definitions in mdio.h - the naming convention is of
> the format "MDIO_mmd_register_bit" where the bit is specific to a MMD,
> or "MDIO_register_bit" where it is non-specific (e.g. the status
> register 1 link status bit.)
> 
>> Anyway, what I want are the PCS/PMA speeds from the 2018 revision, which
>> this phy seems to follow.
> 
> I think we should add further entries for the PMA/PMD speed register.
> For example, 2.5G is bit 13 and 5G is bit 14. (vs bits 6 and 7 for the
> PCS MMD version of the speed register.)
> 

Yes. I will do this for v3.

--Sean