Re: [PATCH v3 2/2] spi: Add Socionext F_OSPI SPI flash controller driver

From: Kunihiko Hayashi
Date: Tue Nov 29 2022 - 19:47:43 EST


Hi Geert,

On 2022/11/30 1:49, Geert Uytterhoeven wrote:
Hi Hayashi-san,

On Thu, Nov 24, 2022 at 1:36 AM Kunihiko Hayashi
<hayashi.kunihiko@xxxxxxxxxxxxx> wrote:
Introduce Socionext F_OSPI controller driver. This controller is used to
communicate with slave devices such as SPI Flash memories. It supports
4 slave devices and up to 8-bit wide bus, but supports master mode only.

This driver uses spi-mem framework for SPI flash memory access, and
can only operate indirect access mode and single data rate mode.

Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@xxxxxxxxxxxxx>

Thanks for your patch, which is now commit 1b74dd64c8612619
("spi: Add Socionext F_OSPI SPI flash controller driver") in
spi/for-next.

Thank you for your work.

--- a/drivers/spi/Kconfig
+++ b/drivers/spi/Kconfig
@@ -906,6 +906,15 @@ config SPI_SLAVE_MT27XX
say Y or M here.If you are not sure, say N.
SPI slave drivers for Mediatek MT27XX series ARM SoCs.

+config SPI_SN_F_OSPI
+ tristate "Socionext F_OSPI SPI flash controller"
+ depends on OF && HAS_IOMEM
+ depends on SPI_MEM

On which systems is this hardware block found?
Perhaps this should depend on ARCH_UNIPHIER || COMPILE_TEST?

This IP doesn't depend on ARCH_UNIPHIER, so I expect that it can be widely
applied not only to ARCH_UNIPHIER.

If COMPILE_TEST is required, the dependency is like SPI_CADENCE_XSPI:
depends on (OF || COMPILE_TEST) && HAS_IOMEM

Thank you,

---
Best Regards
Kunihiko Hayashi