RE: [PATCH net-next v2 2/2] dsa: lan9303: Move to PHYLINK
From: Jerry.Ray
Date: Tue Dec 06 2022 - 11:49:12 EST
>> -static void lan9303_adjust_link(struct dsa_switch *ds, int port,
>> - struct phy_device *phydev)
>> -{
>> - struct lan9303 *chip = ds->priv;
>> - int ctl;
>> -
>> - if (!phy_is_pseudo_fixed_link(phydev))
>> - return;
>> -
>> - ctl = lan9303_phy_read(ds, port, MII_BMCR);
>> -
>> - ctl &= ~BMCR_ANENABLE;
>> -
>> - if (phydev->speed == SPEED_100)
>> - ctl |= BMCR_SPEED100;
>> - else if (phydev->speed == SPEED_10)
>> - ctl &= ~BMCR_SPEED100;
>> - else
>> - dev_err(ds->dev, "unsupported speed: %d\n", phydev->speed);
>> -
>> - if (phydev->duplex == DUPLEX_FULL)
>> - ctl |= BMCR_FULLDPLX;
>> - else
>> - ctl &= ~BMCR_FULLDPLX;
>> -
>> - lan9303_phy_write(ds, port, MII_BMCR, ctl);
>> -
>> - if (port == chip->phy_addr_base) {
>> - /* Virtual Phy: Remove Turbo 200Mbit mode */
>> - lan9303_read(chip->regmap, LAN9303_VIRT_SPECIAL_CTRL, &ctl);
>> -
>> - ctl &= ~LAN9303_VIRT_SPECIAL_TURBO;
>> - regmap_write(chip->regmap, LAN9303_VIRT_SPECIAL_CTRL, ctl);
>> - }
>> -}
>
>Is this functionality no longer necessary? For example, I don't see
>anywhere else in the driver that this turbo mode is disabled.
>
>I'm guessing the above code writing MII_BMCR is to force the
>configuration of integrated PHYs to be the fixed-link settings?
>How is that dealt with after the removal of the above code?
>
While it should be disabled by the HW config strap settings, I'll add
disabling Turbo Mode into the initialization sequence to keep the driver
operation consistent.
>> -
>> static int lan9303_port_enable(struct dsa_switch *ds, int port,
>> struct phy_device *phy)
>> {
>> @@ -1279,6 +1243,41 @@ static int lan9303_port_mdb_del(struct dsa_switch *ds, int port,
>> return 0;
>> }
>>
>> +static void lan9303_phylink_get_caps(struct dsa_switch *ds, int port,
>> + struct phylink_config *config)
>> +{
>> + struct lan9303 *chip = ds->priv;
>> +
>> + dev_dbg(chip->dev, "%s(%d) entered.", __func__, port);
>> +
>> + config->mac_capabilities = MAC_10 | MAC_100 | MAC_ASYM_PAUSE |
>> + MAC_SYM_PAUSE;
>> +
>> + if (dsa_port_is_cpu(dsa_to_port(ds, port))) {
>> + /* cpu port */
>> + phy_interface_empty(config->supported_interfaces);
>
>This should not be necessary - the supported_interfaces member should
>already be zero.
>
>Thanks.
>
Yes, I agree. I'll remove it.
Regards,
J.