[PATCH] arm64: dts: zynqmp: Add mode-pin GPIO controller DT node

[Michal Simek]

From: Piyush Mehta <piyush.mehta@xxxxxxxxxx>

Add mode-pin GPIO controller DT node in zynqmp.dtsi and wire it to usb0
controller. All Xilinx evaluation boards are using modepin gpio for ULPI
reset that's why wire it directly in zynqmp instead of c&p the same line to
every board specific file.

Signed-off-by: Piyush Mehta <piyush.mehta@xxxxxxxxxx>
Signed-off-by: Michal Simek <michal.simek@xxxxxxxxxx>
Signed-off-by: Michal Simek <michal.simek@xxxxxxx>
---

 arch/arm64/boot/dts/xilinx/zynqmp.dtsi | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
index 99273cbbc75f..8553299f12eb 100644
--- a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
+++ b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
@@ -13,6 +13,7 @@
  */
 
 #include <dt-bindings/dma/xlnx-zynqmp-dpdma.h>
+#include <dt-bindings/gpio/gpio.h>
 #include <dt-bindings/power/xlnx-zynqmp-power.h>
 #include <dt-bindings/reset/xlnx-zynqmp-resets.h>
 
@@ -183,6 +184,12 @@ pinctrl0: pinctrl {
 				compatible = "xlnx,zynqmp-pinctrl";
 				status = "disabled";
 			};
+
+			modepin_gpio: gpio {
+				compatible = "xlnx,zynqmp-gpio-modepin";
+				gpio-controller;
+				#gpio-cells = <2>;
+			};
 		};
 	};
 
@@ -814,6 +821,7 @@ usb0: usb@ff9d0000 {
 				 <&zynqmp_reset ZYNQMP_RESET_USB0_HIBERRESET>,
 				 <&zynqmp_reset ZYNQMP_RESET_USB0_APB>;
 			reset-names = "usb_crst", "usb_hibrst", "usb_apbrst";
+			reset-gpios = <&modepin_gpio 1 GPIO_ACTIVE_LOW>;
 			ranges;
 
 			dwc3_0: usb@fe200000 {
-- 
2.36.1