Re: [PATCH 00/12] Qcom: LLCC/EDAC: Fix base address used for LLCC banks

[Manivannan Sadhasivam]

Hi Luca,

On Thu, Dec 08, 2022 at 10:16:27AM +0100, Luca Weiss wrote:
> Hi Manivannan,
> 
> On Wed Dec 7, 2022 at 2:59 PM CET, Manivannan Sadhasivam wrote:
> > The Qualcomm LLCC/EDAC drivers were using a fixed register stride for
> > accessing the (Control and Status Regsiters) CSRs of each LLCC bank.
> > This offset only works for some SoCs like SDM845 for which driver support
> > was initially added.
> >     
> > But the later SoCs use different register stride that vary between the
> > banks with holes in-between. So it is not possible to use a single register
> > stride for accessing the CSRs of each bank. By doing so could result in a
> > crash with the current drivers. So far this crash is not reported since
> > EDAC_QCOM driver is not enabled in ARM64 defconfig and no one tested the
> > driver extensively by triggering the EDAC IRQ (that's where each bank
> > CSRs are accessed).
> >     
> > For fixing this issue, let's obtain the base address of each LLCC bank from
> > devicetree and get rid of the fixed stride.
> >
> > This series affects multiple platforms but I have only tested this on
> > SM8250 and SM8450. Testing on other platforms is welcomed.
> 
> If you can tell me *how* I can test it, I'd be happy to test the series
> on sm6350, like how to trigger the EDAC IRQ.
> 

I suppose there is no manual way to trigger EDAC IRQ on Qcom platforms.
For testing the series, I manually called the EDAC IRQ handler to verify
that it doesn't crash reading the registers.

> So far without any extra patches I don't even see the driver probing,
> with this in kconfig
> 
>   +CONFIG_EDAC=y
>   +CONFIG_EDAC_QCOM=y
> 
> I do have /sys/bus/platform/drivers/qcom_llcc_edac at runtime but
> nothing in there (except bind, uevent and unbind), and also nothing
> interesting in dmesg with "llcc", with edac there's just this message:
> 
>   [    0.064800] EDAC MC: Ver: 3.0.0
> 
> From what I'm seeing now the edac driver is only registered if the
> interrupt is specified but it doesn't seem like sm6350 (=lagoon) has
> this irq? Downstream dts is just this:
> 

Right. The upstream EDAC driver only works in IRQ mode. So you need the
interrupts property in LLCC devicetree node for probing.

> 	cache-controller@9200000 {
> 		compatible = "lagoon-llcc-v1";
> 		reg = <0x9200000 0x50000> , <0x9600000 0x50000>;
> 		reg-names = "llcc_base", "llcc_broadcast_base";
> 		cap-based-alloc-and-pwr-collapse;
> 	};
> 
> From looking at the downstream code, perhaps it's using the polling mode
> there?
> 
> 	/* Request for ecc irq */
> 	ecc_irq = llcc_driv_data->ecc_irq;
> 	if (ecc_irq < 0) {
> 		dev_info(dev, "No ECC IRQ; defaulting to polling mode\n");
> 

In the next version, I will add polling support so that you can test the
series on your platform without any hacks.

Thanks,
Mani

> Let me know what you think.
> 
> Regards
> Luca
> 
> >
> > Thanks,
> > Mani
> >
> > Manivannan Sadhasivam (12):
> >   dt-bindings: arm: msm: Update the maintainers for LLCC
> >   dt-bindings: arm: msm: Fix register regions used for LLCC banks
> >   arm64: dts: qcom: sdm845: Fix the base addresses of LLCC banks
> >   arm64: dts: qcom: sc7180: Fix the base addresses of LLCC banks
> >   arm64: dts: qcom: sc7280: Fix the base addresses of LLCC banks
> >   arm64: dts: qcom: sc8280xp: Fix the base addresses of LLCC banks
> >   arm64: dts: qcom: sm8150: Fix the base addresses of LLCC banks
> >   arm64: dts: qcom: sm8250: Fix the base addresses of LLCC banks
> >   arm64: dts: qcom: sm8350: Fix the base addresses of LLCC banks
> >   arm64: dts: qcom: sm8450: Fix the base addresses of LLCC banks
> >   arm64: dts: qcom: sm6350: Fix the base addresses of LLCC banks
> >   qcom: llcc/edac: Fix the base address used for accessing LLCC banks
> >
> >  .../bindings/arm/msm/qcom,llcc.yaml           | 128 ++++++++++++++++--
> >  arch/arm64/boot/dts/qcom/sc7180.dtsi          |   2 +-
> >  arch/arm64/boot/dts/qcom/sc7280.dtsi          |   5 +-
> >  arch/arm64/boot/dts/qcom/sc8280xp.dtsi        |  10 +-
> >  arch/arm64/boot/dts/qcom/sdm845.dtsi          |   7 +-
> >  arch/arm64/boot/dts/qcom/sm6350.dtsi          |   2 +-
> >  arch/arm64/boot/dts/qcom/sm8150.dtsi          |   7 +-
> >  arch/arm64/boot/dts/qcom/sm8250.dtsi          |   7 +-
> >  arch/arm64/boot/dts/qcom/sm8350.dtsi          |   7 +-
> >  arch/arm64/boot/dts/qcom/sm8450.dtsi          |   7 +-
> >  drivers/edac/qcom_edac.c                      |  14 +-
> >  drivers/soc/qcom/llcc-qcom.c                  |  64 +++++----
> >  include/linux/soc/qcom/llcc-qcom.h            |   4 +-
> >  13 files changed, 197 insertions(+), 67 deletions(-)
> >
> > -- 
> > 2.25.1
> 

-- 
மணிவண்ணன் சதாசிவம்