Re: [PATCH v2 1/1] i2c: designware: set pinctrl recovery information from device pinctrl

[Andy Shevchenko]

On Wed, Dec 14, 2022 at 02:27:25PM +0000, Hanna Hawa wrote:
> The current implementation of designware recovery mechanism fit for
> specific device (Intel / Altera Cyclone V SOC) which have two separated
> "wired" GPIOs to the i2c bus via the SOC FPGA for the i2c recovery.
> 
> Make pinctrl recovery information to points to the device pinctrl by
> setting the rinfo->pinctrl to dev->pins->p.

> Change Log v1->v2:
> - set the rinfo->pinctrl to dev->pins->p instead calling
>   devm_pinctrl_get().

Wrong place for a changelog...

> Signed-off-by: Hanna Hawa <hhhawa@xxxxxxxxxx>
> ---

...should be located here.

...

> +	if (dev->dev->pins && dev->dev->pins->p)
> +		rinfo->pinctrl = dev->dev->pins->p;

Hmm... I don't see how this field is being used.
Can you elaborate?

-- 
With Best Regards,
Andy Shevchenko