Re: [PATCH v6 2/2] arm64: dts: mt8195: Add Ethernet controller

[Andrew Lunn]

> --- a/arch/arm64/boot/dts/mediatek/mt8195-demo.dts
> +++ b/arch/arm64/boot/dts/mediatek/mt8195-demo.dts
> @@ -258,6 +258,66 @@ &mt6359_vsram_others_ldo_reg {
>  };
>  
> +&eth {
> +	phy-mode ="rgmii-id";
> +	phy-handle = <&ethernet_phy0>;
> +	snps,reset-gpio = <&pio 93 GPIO_ACTIVE_HIGH>;
> +	snps,reset-delays-us = <0 10000 10000>;
> +	pinctrl-names = "default", "sleep";
> +	pinctrl-0 = <&eth_default_pins>;
> +	pinctrl-1 = <&eth_sleep_pins>;
> +	status = "okay";
> +
> +	mdio {
> +		compatible = "snps,dwmac-mdio";
> +		#address-cells = <1>;
> +		#size-cells = <0>;

The mdio bus master is a property of the SoC, not the board. So i
would expect it be in the .dtsi file.

> +		ethernet_phy0: ethernet-phy@1 {
> +			compatible = "ethernet-phy-id001c.c916";
> +			reg = <0x1>;
> +		};

Is the PHY integrated into the SoC, or on the board?

You also don't need the compatible, if the PHY correctly implements
the ID registers.

   Andrew