[PATCH 2/9] dt-bindings: pinctrl: qcom,sc8280xp-lpass-lpi: add input-enable and bias-bus-hold

[Krzysztof Kozlowski]

Allow bias-bus-hold and input-enable properties (already used in
SC8280XP LPASS LPI nodes):

  sa8540p-ride.dtb: pinctrl@33c0000: tx-swr-default-state: 'oneOf' conditional failed, one must be fixed:
    'pins' is a required property
    'function' is a required property
    'clk-pins', 'data-pins' do not match any of the regexes: 'pinctrl-[0-9]+'
    'bias-bus-hold' does not match any of the regexes: 'pinctrl-[0-9]+'
    'gpio2' does not match '^gpio([0-1]|1[0-8])$'

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
 .../bindings/pinctrl/qcom,sc8280xp-lpass-lpi-pinctrl.yaml   | 6 ++----
 1 file changed, 2 insertions(+), 4 deletions(-)

diff --git a/Documentation/devicetree/bindings/pinctrl/qcom,sc8280xp-lpass-lpi-pinctrl.yaml b/Documentation/devicetree/bindings/pinctrl/qcom,sc8280xp-lpass-lpi-pinctrl.yaml
index 309d3dd9013b..9a3f1fb8c2f7 100644
--- a/Documentation/devicetree/bindings/pinctrl/qcom,sc8280xp-lpass-lpi-pinctrl.yaml
+++ b/Documentation/devicetree/bindings/pinctrl/qcom,sc8280xp-lpass-lpi-pinctrl.yaml
@@ -94,14 +94,12 @@ $defs:
           2: Lower Slew rate (slower edges)
           3: Reserved (No adjustments)
 
+      bias-bus-hold: true
       bias-pull-down: true
-
       bias-pull-up: true
-
       bias-disable: true
-
+      input-enable: true
       output-high: true
-
       output-low: true
 
     required:
-- 
2.34.1