Re: [PATCH net-next v1 1/3] dt-bindings: net: Add Motorcomm yt8xxx ethernet phy Driver bindings

[Krzysztof Kozlowski]

On 05/01/2023 08:30, Frank wrote:
> Add a YAML binding document for the Motorcom yt8xxx Ethernet phy driver.
> 

Subject: drop second, redundant "Driver bindings".

> Signed-off-by: Frank <Frank.Sae@xxxxxxxxxxxxxx>

Use full first and last name. Your email suggests something more than
only "Frank".

> ---
>  .../bindings/net/motorcomm,yt8xxx.yaml        | 180 ++++++++++++++++++
>  .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
>  MAINTAINERS                                   |   1 +
>  3 files changed, 183 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml
> 
> diff --git a/Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml b/Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml
> new file mode 100644
> index 000000000000..337a562d864c
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/motorcomm,yt8xxx.yaml
> @@ -0,0 +1,180 @@
> +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
> +%YAML 1.2
> +---
> +$id: http://devicetree.org/schemas/net/motorcomm,yt8xxx.yaml#
> +$schema: http://devicetree.org/meta-schemas/core.yaml#
> +
> +title: MotorComm yt8xxx Ethernet PHY
> +
> +maintainers:
> +  - frank <frank.sae@xxxxxxxxxxxxxx>
> +
> +description: |
> +  Bindings for MotorComm yt8xxx PHYs.

Instead describe the hardware. No need to state the obvious that these
are bindings.

> +  yt8511 will be supported later.

Bindings should be complete. Your driver support is not relevant here.

> +
> +allOf:
> +  - $ref: ethernet-phy.yaml#
> +
> +properties:
> +  motorcomm,clk-out-frequency:

Use property suffixes matching the type.

> +    description: clock output in Hertz on clock output pin.

Drop "Hertz". It should be obvious from the suffix.

> +    $ref: /schemas/types.yaml#/definitions/uint32

Drop.

Anyway, does it fit standard clock-frequency property?

> +    enum: [0, 25000000, 125000000]
> +    default: 0
> +
> +  motorcomm,rx-delay-basic:
> +    description: |
> +      Tristate, setup the basic RGMII RX Clock delay of PHY.
> +      This basic delay is fixed at 2ns (1000Mbps) or 8ns (100Mbps、10Mbps).
> +      This basic delay usually auto set by hardware according to the voltage
> +      of RXD0 pin (low = 0, turn off;   high = 1, turn on).
> +      If not exist, this delay is controlled by hardware.

I don't understand that at all. What "not exist"? There is no verb and
no subject.

The type and description are really unclear.

> +      0: turn off;   1: turn on.
> +    $ref: /schemas/types.yaml#/definitions/uint32
> +    enum: [0, 1]

So this is bool?

> +
> +  motorcomm,rx-delay-additional-ps:
> +    description: |
> +      Setup the additional RGMII RX Clock delay of PHY defined in pico seconds.
> +      RGMII RX Clock Delay = rx-delay-basic + rx-delay-additional-ps.
> +    enum:

Best regards,
Krzysztof