Re: [PATCH 2/4] Revert "arm64: dts: renesas: Add compatible properties to AR8031 Ethernet PHYs"
From: Geert Uytterhoeven
Date: Fri Jan 06 2023 - 09:28:23 EST
Hi Adam,
CC Ethernet phy
On Wed, Jan 4, 2023 at 3:12 PM Adam Ford <aford173@xxxxxxxxx> wrote:
> This reverts commit 18a2427146bf8a3da8fc7825051d6aadb9c2d8fb.
>
> Due to the part shortage, the AR8031 PHY was replaced with a
> Micrel KSZ9131. Hard-coding the ID of the PHY makes this new
> PHY non-operational. Since previous hardware had shipped,
> it's not as simple as just replacing the ID number as it would
> break the older hardware. Since the generic mode can correctly
> identify both versions of hardware, it seems safer to revert
> this patch.
>
> Signed-off-by: Adam Ford <aford173@xxxxxxxxx>
Thanks for your patch!
> --- a/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
> +++ b/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
> @@ -59,8 +59,6 @@ &avb {
> status = "okay";
>
> phy0: ethernet-phy@0 {
> - compatible = "ethernet-phy-id004d.d074",
> - "ethernet-phy-ieee802.3-c22";
> reg = <0>;
> interrupt-parent = <&gpio2>;
> interrupts = <11 IRQ_TYPE_LEVEL_LOW>;
The next line:
reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>;
Unfortunately, removing the compatible value will cause regressions
for kexec/kdump and for Ethernet driver unbind, as the PHY reset will
be asserted before starting the new kernel, or on driver unbind.
Due to a deficiency in the Ethernet PHY subsystem, the PHY will be
probed while the reset is still asserted, and thus fail probing[1].
Is there a (new) proper way to handle this?
Perhaps the issue has been fixed in the PHY subsystem meanwhile?
Thanks!
[1] https://lore.kernel.org/all/cover.1631174218.git.geert+renesas@xxxxxxxxx
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert@xxxxxxxxxxxxxx
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds