[RFC PATCH v2 3/5] iio: adc: qcom-spmi-adc5: Fall back to datasheet_name instead of fwnode name

[Marijn Suijten]

Since the migration to fwnode_get_name in commit 4f47a236a23d ("iio:
adc: qcom-spmi-adc5: convert to device properties") the resulting
adc5_channel_prop::channel_name (renamed from datasheet_name in the
previous patch) - which is propagated into iio_chan_spec::extend_name -
was containing the DT node name including @xx suffix if a "label"
property is not present, while adc5_channels::datasheet_name was thus
far set by the macros but always remained unread.  Put it to use instead
of using a confusing name containing @xx in sysfs filenames (again, when
"label" is not set).

Signed-off-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
---

Note that for this to make sense a successor to "arm64: dts: qcom: Use
labels with generic node names for ADC channels" [1] will have to land,
otherwise most channels that currently pull datasheet_name/extend_name
from DT fall back to datasheet_name hardcoded in this driver.

[1]: https://lore.kernel.org/linux-arm-msm/20221209215308.1781047-1-marijn.suijten@xxxxxxxxxxxxxx/

 drivers/iio/adc/qcom-spmi-adc5.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/iio/adc/qcom-spmi-adc5.c b/drivers/iio/adc/qcom-spmi-adc5.c
index 26144a086fac..01aafd9df6c6 100644
--- a/drivers/iio/adc/qcom-spmi-adc5.c
+++ b/drivers/iio/adc/qcom-spmi-adc5.c
@@ -661,7 +661,7 @@ static int adc5_get_fw_channel_data(struct adc5_chip *adc,
 
 	ret = fwnode_property_read_string(fwnode, "label", &channel_name);
 	if (ret)
-		channel_name = name;
+		channel_name = data->adc_chans[chan].datasheet_name;
 
 	prop->channel_name = channel_name;
 
-- 
2.39.0