[PATCH v2 19/19] ARM: dts: imx6ul-prti6g: configure ethernet reference clock parent

[Oleksij Rempel]

On this board the PHY is the ref clock provider. So, configure ethernet
reference clock as input.

Without this patch we have relatively high amount of dropped packets.

Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
 arch/arm/boot/dts/imx6ul-prti6g.dts | 14 ++++++++------
 1 file changed, 8 insertions(+), 6 deletions(-)

diff --git a/arch/arm/boot/dts/imx6ul-prti6g.dts b/arch/arm/boot/dts/imx6ul-prti6g.dts
index c18390f238e1..b7c96fbe7a91 100644
--- a/arch/arm/boot/dts/imx6ul-prti6g.dts
+++ b/arch/arm/boot/dts/imx6ul-prti6g.dts
@@ -26,6 +26,7 @@ clock_ksz8081_out: clock-ksz8081-out {
 		compatible = "fixed-clock";
 		#clock-cells = <0>;
 		clock-frequency = <50000000>;
+		clock-output-names = "enet1_ref_pad";
 	};
 
 	leds {
@@ -60,6 +61,13 @@ &can2 {
 	status = "okay";
 };
 
+&clks {
+	clocks = <&ckil>, <&osc>, <&ipp_di0>, <&ipp_di1>, <&clock_ksz8081_out>;
+	clock-names = "ckil", "osc", "ipp_di0", "ipp_di1", "enet1_ref_pad";
+	assigned-clocks = <&clks IMX6UL_CLK_ENET1_REF_SEL>;
+	assigned-clock-parents = <&clock_ksz8081_out>;
+};
+
 &ecspi1 {
 	cs-gpios = <&gpio4 26 GPIO_ACTIVE_LOW>;
 	pinctrl-names = "default";
@@ -85,12 +93,6 @@ &fec1 {
 	pinctrl-0 = <&pinctrl_eth1>;
 	phy-mode = "rmii";
 	phy-handle = <&rmii_phy>;
-	clocks = <&clks IMX6UL_CLK_ENET>,
-		 <&clks IMX6UL_CLK_ENET_AHB>,
-		 <&clks IMX6UL_CLK_ENET_PTP>,
-		 <&clock_ksz8081_out>;
-	clock-names = "ipg", "ahb", "ptp",
-		      "enet_clk_ref";
 	status = "okay";
 
 	mdio {
-- 
2.30.2