Re: [PATCH net-next v5 0/4] phy: aquantia: Determine rate adaptation support from registers

[Sean Anderson]

On 1/3/23 17:05, Sean Anderson wrote:
> This attempts to address the problems first reported in [1]. Tim has an
> Aquantia phy where the firmware is set up to use "5G XFI" (underclocked
> 10GBASE-R) when rate adapting lower speeds. This results in us
> advertising that we support lower speeds and then failing to bring the
> link up. To avoid this, determine whether to enable rate adaptation
> based on what's programmed by the firmware. This is "the worst choice"
> [2], but we can't really do better until we have more insight into
> what the firmware is doing. At the very least, we can prevent bad
> firmware from causing us to advertise the wrong modes.
> 
> Past submissions may be found at [3, 4].
> 
> [1] https://lore.kernel.org/netdev/CAJ+vNU3zeNqiGhjTKE8jRjDYR0D7f=iqPLB8phNyA2CWixy7JA@xxxxxxxxxxxxxx/
> [2] https://lore.kernel.org/netdev/20221118171643.vu6uxbnmog4sna65@skbuf/
> [3] https://lore.kernel.org/netdev/20221114210740.3332937-1-sean.anderson@xxxxxxxx/
> [4] https://lore.kernel.org/netdev/20221128195409.100873-1-sean.anderson@xxxxxxxx/
> 
> Changes in v5:
> - Add missing PMA/PMD speed bits
> - Don't handle PHY_INTERFACE_MODE_NA, and simplify logic
> 
> Changes in v4:
> - Reorganize MDIO defines
> - Fix kerneldoc using - instead of : for parameters
> 
> Changes in v3:
> - Update speed register bits
> - Fix incorrect bits for PMA/PMD speed
> 
> Changes in v2:
> - Move/rename phylink_interface_max_speed
> - Rework to just validate things instead of modifying registers
> 
> Sean Anderson (4):
>   net: phy: Move/rename phylink_interface_max_speed
>   phy: mdio: Reorganize defines
>   net: mdio: Update speed register bits
>   phy: aquantia: Determine rate adaptation support from registers
> 
>  drivers/net/phy/aquantia_main.c | 136 ++++++++++++++++++++++++++++++--
>  drivers/net/phy/phy-core.c      |  70 ++++++++++++++++
>  drivers/net/phy/phylink.c       |  75 +-----------------
>  include/linux/phy.h             |   1 +
>  include/uapi/linux/mdio.h       | 118 ++++++++++++++++++---------
>  5 files changed, 282 insertions(+), 118 deletions(-)
> 

Although there was a lot of discussion about the final patch, I think the
first 3 are good changes. Can we apply them as-is? Should I resubmit?

--Sean