[PATCH v2 net-next] net: phy: microchip: run phy initialization during each link update

[Rakesh Sankaranarayanan]

PHY initialization is supposed to run on every mode changes.
"lan87xx_config_aneg()" verifies every mode change using
"phy_modify_changed()" function. Earlier code had phy_modify_changed()
followed by genphy_soft_reset. But soft_reset resets all the
pre-configured register values to default state, and lost all the
initialization done. With this reason gen_phy_reset was removed.
But it need to go through init sequence each time the mode changed.
Update lan87xx_config_aneg() to invoke phy_init once successful mode
update is detected.

PHY init sequence added in lan87xx_phy_init() have slave init
commands executed every time. Update the init sequence to run
slave init only if phydev is in slave mode.

Test setup contains LAN9370 EVB connected to SAMA5D3 (Running DSA),
and issue can be reproduced by connecting link to any of the available
ports after SAMA5D3 boot-up. With this issue, port will fail to
update link state. But once the SAMA5D3 is reset with LAN9370 link in
connected state itself, on boot-up link state will be reported as UP. But
Again after some time, if link is moved to DOWN state, it will not get
reported.

Signed-off-by: Rakesh Sankaranarayanan <rakesh.sankaranarayanan@xxxxxxxxxxxxx>

---

v1 -> v2:
- Separated patch from series and added as independent patch.
- Patch prefix updated for path drivers/net/phy.
- Patch tagged for net-next instead of net.
- Code comment updated based on review.

---
---
 drivers/net/phy/microchip_t1.c | 70 +++++++++++++++++++++++++++-------
 1 file changed, 56 insertions(+), 14 deletions(-)

diff --git a/drivers/net/phy/microchip_t1.c b/drivers/net/phy/microchip_t1.c
index 8569a545e0a3..a838b61cd844 100644
--- a/drivers/net/phy/microchip_t1.c
+++ b/drivers/net/phy/microchip_t1.c
@@ -245,15 +245,42 @@ static int lan87xx_config_rgmii_delay(struct phy_device *phydev)
 			   PHYACC_ATTR_BANK_MISC, LAN87XX_CTRL_1, rc);
 }
 
+static int lan87xx_phy_init_cmd(struct phy_device *phydev,
+				const struct access_ereg_val *cmd_seq, int cnt)
+{
+	int ret, i;
+
+	for (i = 0; i < cnt; i++) {
+		if (cmd_seq[i].mode == PHYACC_ATTR_MODE_POLL &&
+		    cmd_seq[i].bank == PHYACC_ATTR_BANK_SMI) {
+			ret = access_smi_poll_timeout(phydev,
+						      cmd_seq[i].offset,
+						      cmd_seq[i].val,
+						      cmd_seq[i].mask);
+		} else {
+			ret = access_ereg(phydev, cmd_seq[i].mode,
+					  cmd_seq[i].bank, cmd_seq[i].offset,
+					  cmd_seq[i].val);
+		}
+		if (ret < 0)
+			return ret;
+	}
+
+	return ret;
+}
+
 static int lan87xx_phy_init(struct phy_device *phydev)
 {
-	static const struct access_ereg_val init[] = {
+	static const struct access_ereg_val hw_init[] = {
 		/* TXPD/TXAMP6 Configs */
 		{ PHYACC_ATTR_MODE_WRITE, PHYACC_ATTR_BANK_AFE,
 		  T1_AFE_PORT_CFG1_REG,       0x002D,  0 },
 		/* HW_Init Hi and Force_ED */
 		{ PHYACC_ATTR_MODE_WRITE, PHYACC_ATTR_BANK_SMI,
 		  T1_POWER_DOWN_CONTROL_REG,  0x0308,  0 },
+	};
+
+	static const struct access_ereg_val slave_init[] = {
 		/* Equalizer Full Duplex Freeze - T1 Slave */
 		{ PHYACC_ATTR_MODE_WRITE, PHYACC_ATTR_BANK_DSP,
 		  T1_EQ_FD_STG1_FRZ_CFG,     0x0002,  0 },
@@ -267,6 +294,9 @@ static int lan87xx_phy_init(struct phy_device *phydev)
 		  T1_EQ_WT_FD_LCK_FRZ_CFG,    0x0002,  0 },
 		{ PHYACC_ATTR_MODE_WRITE, PHYACC_ATTR_BANK_DSP,
 		  T1_PST_EQ_LCK_STG1_FRZ_CFG, 0x0002,  0 },
+	};
+
+	static const struct access_ereg_val phy_init[] = {
 		/* Slave Full Duplex Multi Configs */
 		{ PHYACC_ATTR_MODE_WRITE, PHYACC_ATTR_BANK_DSP,
 		  T1_SLV_FD_MULT_CFG_REG,     0x0D53,  0 },
@@ -397,7 +427,7 @@ static int lan87xx_phy_init(struct phy_device *phydev)
 		{ PHYACC_ATTR_MODE_WRITE, PHYACC_ATTR_BANK_SMI,
 		  T1_POWER_DOWN_CONTROL_REG,	0x0300, 0 },
 	};
-	int rc, i;
+	int rc;
 
 	/* phy Soft reset */
 	rc = genphy_soft_reset(phydev);
@@ -405,21 +435,28 @@ static int lan87xx_phy_init(struct phy_device *phydev)
 		return rc;
 
 	/* PHY Initialization */
-	for (i = 0; i < ARRAY_SIZE(init); i++) {
-		if (init[i].mode == PHYACC_ATTR_MODE_POLL &&
-		    init[i].bank == PHYACC_ATTR_BANK_SMI) {
-			rc = access_smi_poll_timeout(phydev,
-						     init[i].offset,
-						     init[i].val,
-						     init[i].mask);
-		} else {
-			rc = access_ereg(phydev, init[i].mode, init[i].bank,
-					 init[i].offset, init[i].val);
-		}
+	rc = lan87xx_phy_init_cmd(phydev, hw_init, ARRAY_SIZE(hw_init));
+	if (rc < 0)
+		return rc;
+
+	rc = genphy_read_master_slave(phydev);
+	if (rc)
+		return rc;
+
+	/* The following squence needs to run only if phydev is in
+	 * slave mode.
+	 */
+	if (phydev->master_slave_state == MASTER_SLAVE_STATE_SLAVE) {
+		rc = lan87xx_phy_init_cmd(phydev, slave_init,
+					  ARRAY_SIZE(slave_init));
 		if (rc < 0)
 			return rc;
 	}
 
+	rc = lan87xx_phy_init_cmd(phydev, phy_init, ARRAY_SIZE(phy_init));
+	if (rc < 0)
+		return rc;
+
 	return lan87xx_config_rgmii_delay(phydev);
 }
 
@@ -775,6 +812,7 @@ static int lan87xx_read_status(struct phy_device *phydev)
 static int lan87xx_config_aneg(struct phy_device *phydev)
 {
 	u16 ctl = 0;
+	int ret;
 
 	switch (phydev->master_slave_set) {
 	case MASTER_SLAVE_CFG_MASTER_FORCE:
@@ -790,7 +828,11 @@ static int lan87xx_config_aneg(struct phy_device *phydev)
 		return -EOPNOTSUPP;
 	}
 
-	return phy_modify_changed(phydev, MII_CTRL1000, CTL1000_AS_MASTER, ctl);
+	ret = phy_modify_changed(phydev, MII_CTRL1000, CTL1000_AS_MASTER, ctl);
+	if (ret == 1)
+		return phy_init_hw(phydev);
+
+	return ret;
 }
 
 static int lan87xx_get_sqi(struct phy_device *phydev)
-- 
2.34.1