[PATCH RESEND] tty: serial: fsl_lpuart: don't enable receiver/transmitter before rx/tx dma ready

[Sherry Sun]

lpuart32_setup_watermark_enable() will configure the UART FIFO and
watermark, also enable the receiver and transmitter, this should be done
after the rx/tx dma steup ready.

Also add lpuart32_hw_disable() to make sure the receiver/transmitter and
interrupts are disabled during the dma steup.

Signed-off-by: Sherry Sun <sherry.sun@xxxxxxx>
---
 drivers/tty/serial/fsl_lpuart.c | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index 04fecff2fa5f..eac5243a9db0 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -1702,6 +1702,16 @@ static int lpuart_startup(struct uart_port *port)
 	return 0;
 }
 
+static void lpuart32_hw_disable(struct lpuart_port *sport)
+{
+	unsigned long temp;
+
+	temp = lpuart32_read(&sport->port, UARTCTRL);
+	temp &= ~(UARTCTRL_RIE | UARTCTRL_ILIE | UARTCTRL_RE |
+		  UARTCTRL_TIE | UARTCTRL_TE);
+	lpuart32_write(&sport->port, temp, UARTCTRL);
+}
+
 static void lpuart32_configure(struct lpuart_port *sport)
 {
 	unsigned long temp;
@@ -1726,11 +1736,12 @@ static void lpuart32_hw_setup(struct lpuart_port *sport)
 
 	spin_lock_irqsave(&sport->port.lock, flags);
 
-	lpuart32_setup_watermark_enable(sport);
+	lpuart32_hw_disable(sport);
 
 	lpuart_rx_dma_startup(sport);
 	lpuart_tx_dma_startup(sport);
 
+	lpuart32_setup_watermark_enable(sport);
 	lpuart32_configure(sport);
 
 	spin_unlock_irqrestore(&sport->port.lock, flags);
-- 
2.17.1