Re: [PATCH v3 9/9] arm64: dts: qcom: sa8775p-ride: enable the BT UART port

[Konrad Dybcio]

On 16.02.2023 13:52, Bartosz Golaszewski wrote:
> From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
> 
> Enable the high-speed UART port connected to the Bluetooth controller on
> the sa8775p-adp development board.
> 
> Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
> ---
Same comments as in the previous patch.

Konrad
>  arch/arm64/boot/dts/qcom/sa8775p-ride.dts | 33 +++++++++++++++++++++++
>  1 file changed, 33 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/sa8775p-ride.dts b/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
> index 6f96907b335c..1de3b9d4a05a 100644
> --- a/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
> +++ b/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
> @@ -14,6 +14,7 @@ / {
>  	aliases {
>  		serial0 = &uart10;
>  		serial1 = &uart12;
> +		serial2 = &uart17;
>  		i2c18 = &i2c18;
>  		spi16 = &spi16;
>  	};
> @@ -89,6 +90,29 @@ qup_uart12_tx: qup-uart12-tx-state {
>  	qup_uart12_rx: qup-uart12-rx-state {
>  		pins = "gpio55";
>  		function = "qup1_se5";
> +	};
> +
> +	qup_uart17_cts: qup-uart17-cts-state {
> +		pins = "gpio91";
> +		function = "qup2_se3";
> +		bias-disable;
> +	};
> +
> +	qup_uart17_rts: qup0-uart17-rts-state {
> +		pins = "gpio92";
> +		function = "qup2_se3";
> +		bias-pull-down;
> +	};
> +
> +	qup_uart17_tx: qup0-uart17-tx-state {
> +		pins = "gpio93";
> +		function = "qup2_se3";
> +		bias-pull-up;
> +	};
> +
> +	qup_uart17_rx: qup0-uart17-rx-state {
> +		pins = "gpio94";
> +		function = "qup2_se3";
>  		bias-pull-down;
>  	};
>  };
> @@ -109,6 +133,15 @@ &uart12 {
>  	status = "okay";
>  };
>  
> +&uart17 {
> +	pinctrl-0 = <&qup_uart17_cts>,
> +		    <&qup_uart17_rts>,
> +		    <&qup_uart17_tx>,
> +		    <&qup_uart17_rx>;
> +	pinctrl-names = "default";
> +	status = "okay";
> +};
> +
>  &xo_board_clk {
>  	clock-frequency = <38400000>;
>  };