[PATCH] arm64: dts: amlogic: gxl: use gxl mdio multiplexer

[Jerome Brunet]

So the far, GXL SoCs were using the generic mmio register based mdio
multiplexer. This properly sets one of the glue register but the SoC
actually has 3 of those registers.

One of them sets the ID under which the internal phy will advertise
itself. If nothing sets this register before linux boots (like u-boot), the
internal phy path is broken.

To address this problem, a dedicated MDIO mux driver has been
introduced. Switch to this new driver.

Signed-off-by: Jerome Brunet <jbrunet@xxxxxxxxxxxx>
---
 arch/arm64/boot/dts/amlogic/meson-gxl.dtsi | 25 +++++++++++-----------
 1 file changed, 13 insertions(+), 12 deletions(-)

diff --git a/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
index 6f3c2bc36919..17bcfa4702e1 100644
--- a/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
@@ -773,16 +773,23 @@ mux {
 		};
 	};
 
-	eth-phy-mux@55c {
-		compatible = "mdio-mux-mmioreg", "mdio-mux";
+	eth_phy_mux: mdio@558 {
+		reg = <0x0 0x558 0x0 0xc>;
+		compatible = "amlogic,gxl-mdio-mux";
 		#address-cells = <1>;
 		#size-cells = <0>;
-		reg = <0x0 0x55c 0x0 0x4>;
-		mux-mask = <0xffffffff>;
+		clocks = <&clkc CLKID_FCLK_DIV4>;
+		clock-names = "ref";
 		mdio-parent-bus = <&mdio0>;
 
-		internal_mdio: mdio@e40908ff {
-			reg = <0xe40908ff>;
+		external_mdio: mdio@0 {
+			reg = <0x0>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+		};
+
+		internal_mdio: mdio@1 {
+			reg = <0x1>;
 			#address-cells = <1>;
 			#size-cells = <0>;
 
@@ -793,12 +800,6 @@ internal_phy: ethernet-phy@8 {
 				max-speed = <100>;
 			};
 		};
-
-		external_mdio: mdio@2009087f {
-			reg = <0x2009087f>;
-			#address-cells = <1>;
-			#size-cells = <0>;
-		};
 	};
 };
 
-- 
2.39.2