[PATCH 3/8] Bluetooth: hci_ldisc: Fix tty_set_termios() return value assumptions

[Ilpo Järvinen]

tty_set_termios() never returns anything else than 0. Make the debug
prints to look directly into the new termios instead to check CRTSCTS
state.

Signed-off-by: Ilpo Järvinen <ilpo.jarvinen@xxxxxxxxxxxxxxx>
---
 drivers/bluetooth/hci_ldisc.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/bluetooth/hci_ldisc.c b/drivers/bluetooth/hci_ldisc.c
index 865112e96ff9..efdda2c3fce8 100644
--- a/drivers/bluetooth/hci_ldisc.c
+++ b/drivers/bluetooth/hci_ldisc.c
@@ -323,9 +323,9 @@ void hci_uart_set_flow_control(struct hci_uart *hu, bool enable)
 		/* Disable hardware flow control */
 		ktermios = tty->termios;
 		ktermios.c_cflag &= ~CRTSCTS;
-		status = tty_set_termios(tty, &ktermios);
+		tty_set_termios(tty, &ktermios);
 		BT_DBG("Disabling hardware flow control: %s",
-		       status ? "failed" : "success");
+		       (tty->termios.c_cflag & CRTSCTS) ? "failed" : "success");
 
 		/* Clear RTS to prevent the device from sending */
 		/* Most UARTs need OUT2 to enable interrupts */
@@ -357,9 +357,9 @@ void hci_uart_set_flow_control(struct hci_uart *hu, bool enable)
 		/* Re-enable hardware flow control */
 		ktermios = tty->termios;
 		ktermios.c_cflag |= CRTSCTS;
-		status = tty_set_termios(tty, &ktermios);
+		tty_set_termios(tty, &ktermios);
 		BT_DBG("Enabling hardware flow control: %s",
-		       status ? "failed" : "success");
+		       !(tty->termios.c_cflag & CRTSCTS) ? "failed" : "success");
 	}
 }
 
-- 
2.30.2