Re: [PATCH v2 1/2] PCI/ATS: Add a helper function to configure ATS STU of a PF

From: Bjorn Helgaas
Date: Tue Mar 14 2023 - 13:10:56 EST

Next message: Doug Anderson: "Re: [PATCH] drm/panel: Fix panel mode type setting logic"
Previous message: Serge Semin: "Re: [PATCH net-next 01/16] dt-bindings: net: dwmac: Validate PBL for all IP-cores"
In reply to: Sathyanarayanan Kuppuswamy: "Re: [PATCH v2 1/2] PCI/ATS: Add a helper function to configure ATS STU of a PF"
Next in thread: Ganapatrao Kulkarni: "Re: [PATCH v2 1/2] PCI/ATS: Add a helper function to configure ATS STU of a PF"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

On Tue, Mar 14, 2023 at 09:50:06AM -0700, Sathyanarayanan Kuppuswamy wrote:
> On 3/14/23 9:02 AM, Bjorn Helgaas wrote:
> > On Tue, Mar 14, 2023 at 08:06:07PM +0530, Ganapatrao Kulkarni wrote:
> >> On 14-03-2023 06:22 pm, Sathyanarayanan Kuppuswamy wrote:
> >>> On 3/14/23 3:08 AM, Ganapatrao Kulkarni wrote:
> >>>> On 14-03-2023 04:00 am, Sathyanarayanan Kuppuswamy wrote:
> >>>>> On 3/13/23 2:12 PM, Bjorn Helgaas wrote:
> >>>>>> On Mon, Feb 27, 2023 at 08:21:36PM -0800, Ganapatrao Kulkarni wrote:
> >>>>>>> As per PCI specification (PCI Express Base Specification
> >>>>>>> Revision 6.0, Section 10.5) both PF and VFs of a PCI EP
> >>>>>>> are permitted to be enabled independently for ATS
> >>>>>>> capability, however the STU(Smallest Translation Unit) is
> >>>>>>> shared between PF and VFs. For VFs, it is hardwired to
> >>>>>>> Zero and the associated PF's value applies to VFs.
> >>>>>>>
> >>>>>>> In the current code, the STU is being configured while
> >>>>>>> enabling the PF ATS. Hence, it is not able to enable ATS
> >>>>>>> for VFs, if it is not enabled on the associated PF
> >>>>>>> already.
> >>>>>>>
> >>>>>>> Adding a function pci_ats_stu_configure(), which can be
> >>>>>>> called to configure the STU during PF enumeration. Latter
> >>>>>>> enumerations of VFs can successfully enable ATS
> >>>>>>> independently.
> >
> >>>>>>> @@ -46,6 +46,35 @@ bool pci_ats_supported(struct pci_dev *dev)
> >>>>>>> }
> >>>>>>> EXPORT_SYMBOL_GPL(pci_ats_supported);
> >>>>>>> +/**
> >>>>>>> + * pci_ats_stu_configure - Configure STU of a PF.
> >>>>>>> + * @dev: the PCI device
> >>>>>>> + * @ps: the IOMMU page shift
> >>>>>>> + *
> >>>>>>> + * Returns 0 on success, or negative on failure.
> >>>>>>> + */
> >>>>>>> +int pci_ats_stu_configure(struct pci_dev *dev, int ps)
> >>>>>>> +{
> >>>>>>> +    u16 ctrl;
> >>>>>>> +
> >>>>>>> +    if (dev->ats_enabled || dev->is_virtfn)
> >>>>>>> +        return 0;
> >>>>>>
> >>>>>> I might return an error for the VF case on the assumption
> >>>>>> that it's likely an error in the caller. I guess one could
> >>>>>> argue that it simplifies the caller if it doesn't have to
> >>>>>> check for PF vs VF. But the fact that STU is shared between
> >>>>>> PF and VFs is an important part of understanding how ATS
> >>>>>> works, so the caller should be aware of the distinction
> >>>>>> anyway.
> >>>>>
> >>>>> I have already asked this question. But let me repeat it.
> >>>>>
> >>>>> We don't have any checks for the PF case here. That means you
> >>>>> can re-configure the STU as many times as you want until ATS
> >>>>> is enabled in PF. So, if there are active VFs which uses this
> >>>>> STU, can PF re-configure the STU at will?
> >>>>
> >>>> IMO, Since STU is shared, programming it multiple times is not expected from callers code do it, however we can add below check to allow to program STU once from a PF.
> >>>>
> >>>> diff --git a/drivers/pci/ats.c b/drivers/pci/ats.c
> >>>> index 1611bfa1d5da..f7bb01068e18 100644
> >>>> --- a/drivers/pci/ats.c
> >>>> +++ b/drivers/pci/ats.c
> >>>> @@ -60,6 +60,10 @@ int pci_ats_stu_configure(struct pci_dev *dev, int ps)
> >>>>         if (dev->ats_enabled || dev->is_virtfn)
> >>>>                 return 0;
> >>>>
> >>>> +       /* Configured already */
> >>>> +       if (dev->ats_stu)
> >>>> +               return 0;
> >>>
> >>> Theoretically, you can re-configure STU as long as no one is using
> >>> it. Instead of this check, is there a way to check whether there
> >>> are active VMs which enables ATS?
> >>
> >> Yes I agree, there is no limitation on how many times you write STU
> >> bits, but practically it is happening while PF is enumerated.
> >>
> >> The usage of function pci_ats_stu_configure is almost
> >> similar(subset) to pci_enable_ats and only difference is one does
> >> ATS enable + STU program and another does only STU program.
> >
> > What would you think of removing the STU update feature from
> > pci_enable_ats() so it always fails if pci_ats_stu_configure() has not
> > been called, even when called on the PF, e.g.,
> >
> > if (ps != pci_physfn(dev)->ats_stu)
> > return -EINVAL;
>
> If we are removing the STU update from pci_enable_ats(), why
> even allow passing "ps (page shift)" parameter? IMO, we can assume that
> for STU reconfigure, users will call pci_ats_stu_configure().

The reason to pass "ps" would be to verify that the STU the caller
plans to use matches the actual STU.

> Since zero is a valid STU, enabling ATS can be decoupled from STU
> update.
>
> > pci_read_config_word(dev, dev->ats_cap + PCI_ATS_CTRL, &ctrl);
> > ctrl |= PCI_ATS_CTRL_ENABLE;
> > pci_write_config_word(dev, dev->ats_cap + PCI_ATS_CTRL, ctrl);
> >
> > Would probably also have to set "dev->ats_stu = 0" in
> > pci_disable_ats() to allow the possibility of calling
> > pci_ats_stu_configure() again.
> >
> >> IMO, I dont think, there is any need to find how many active VMs
> >> with attached VFs and it is not done for pci_enable_ats as well.
> >
> > Enabling or disabling ATS in a PF or VF has no effect on other
> > functions.
> >
> > But changing STU while a VF has ATS enabled would definitely break any
> > user of that VF, so if it's practical to verify that no VFs have ATS
> > enabled, I think we should.
>
> I also think it is better to check for a ats_enabled status of VF before
> configuring the STU.
>
> May be something like below (untested),
>
> static int is_ats_enabled_in_vf(struct pci_dev *dev)
> {
> struct pci_sriov *iov = dev->sriov;
> struct pci_dev *vdev;
>
> if (dev->is_virtfn)
> return -EINVAL;
>
> for (i = 0; i < pci_sriov_get_totalvfs(pdev); i++) {
> vdev = pci_get_domain_bus_and_slot(pci_domain_nr(dev->bus),
> pci_iov_virtfn_bus(dev, i),
> pci_iov_virtfn_devfn(dev, i));

I would try hard to avoid pci_get_domain_bus_and_slot(). That's
expensive (searches *all* PCI devs with for_each_pci_dev()) and
requires dealing with reference counts.

Maybe an atomic count in the PF of VFs with ATS enabled.

> if (vdev && vdev->ats_enabled)
> return 1;
> }
>
> return 0;
>
> }
>
> int pci_ats_stu_configure(struct pci_dev *dev, int ps)
> {
> ...
> if (is_ats_enabled_in_vf(dev))
> return -EBUSY;
>
> >
> >> Also the caller has the requirement to call either
> >> pci_ats_stu_configure or pci_enable_ats while enumerating the PF.
> >>
> >>>>         if (!pci_ats_supported(dev))
> >>>>                 return -EINVAL;
> >>>>>>
> >>>>>>> +
> >>>>>>> +    if (!pci_ats_supported(dev))
> >>>>>>> +        return -EINVAL;
> >>>>>>> +
> >>>>>>> +    if (ps < PCI_ATS_MIN_STU)
> >>>>>>> +        return -EINVAL;
> >>>>>>> +
> >>>>>>> +    dev->ats_stu = ps;
> >>>>>>> +    pci_read_config_word(dev, dev->ats_cap + PCI_ATS_CTRL, &ctrl);
> >>>>>>> +    ctrl |= PCI_ATS_CTRL_STU(dev->ats_stu - PCI_ATS_MIN_STU);
> >>>>>>> +    pci_write_config_word(dev, dev->ats_cap + PCI_ATS_CTRL, ctrl);
> >>>>>>> +
> >>>>>>> +    return 0;
> >>>>>>> +}
> >>>>>>> +EXPORT_SYMBOL_GPL(pci_ats_stu_configure);
> >>>>>>> +
> >>>>>>> /**
> >>>>>>>    * pci_enable_ats - enable the ATS capability
> >>>>>>>    * @dev: the PCI device
> >>>>>>> @@ -68,8 +97,8 @@ int pci_enable_ats(struct pci_dev *dev, int ps)
> >>>>>>>           return -EINVAL;
> >>>>>>>       /*
> >>>>>>> -     * Note that enabling ATS on a VF fails unless it's already enabled
> >>>>>>> -     * with the same STU on the PF.
> >>>>>>> +     * Note that enabling ATS on a VF fails unless it's already
> >>>>>>> +     * configured with the same STU on the PF.
> >>>>>>>        */
> >>>>>>>       ctrl = PCI_ATS_CTRL_ENABLE;
> >>>>>>>       if (dev->is_virtfn) {
> >>>>>>> diff --git a/include/linux/pci-ats.h b/include/linux/pci-ats.h
> >>>>>>> index df54cd5b15db..7d62a92aaf23 100644
> >>>>>>> --- a/include/linux/pci-ats.h
> >>>>>>> +++ b/include/linux/pci-ats.h
> >>>>>>> @@ -8,6 +8,7 @@
> >>>>>>> /* Address Translation Service */
> >>>>>>> bool pci_ats_supported(struct pci_dev *dev);
> >>>>>>> int pci_enable_ats(struct pci_dev *dev, int ps);
> >>>>>>> +int pci_ats_stu_configure(struct pci_dev *dev, int ps);
> >>>>>>> void pci_disable_ats(struct pci_dev *dev);
> >>>>>>> int pci_ats_queue_depth(struct pci_dev *dev);
> >>>>>>> int pci_ats_page_aligned(struct pci_dev *dev);
> >>>>>>> @@ -16,6 +17,8 @@ static inline bool pci_ats_supported(struct pci_dev *d)
> >>>>>>> { return false; }
> >>>>>>> static inline int pci_enable_ats(struct pci_dev *d, int ps)
> >>>>>>> { return -ENODEV; }
> >>>>>>> +static inline int pci_ats_stu_configure(struct pci_dev *d, int ps)
> >>>>>>> +{ return -ENODEV; }
> >>>>>>> static inline void pci_disable_ats(struct pci_dev *d) { }
> >>>>>>> static inline int pci_ats_queue_depth(struct pci_dev *d)
> >>>>>>> { return -ENODEV; }
>
> --
> Sathyanarayanan Kuppuswamy
> Linux Kernel Developer
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

Next message: Doug Anderson: "Re: [PATCH] drm/panel: Fix panel mode type setting logic"
Previous message: Serge Semin: "Re: [PATCH net-next 01/16] dt-bindings: net: dwmac: Validate PBL for all IP-cores"
In reply to: Sathyanarayanan Kuppuswamy: "Re: [PATCH v2 1/2] PCI/ATS: Add a helper function to configure ATS STU of a PF"
Next in thread: Ganapatrao Kulkarni: "Re: [PATCH v2 1/2] PCI/ATS: Add a helper function to configure ATS STU of a PF"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]