This reverts commit c2d94f72140a28d0f516b7c5e8274a9c185a04ff.
The `lg_lp120up1_mode` defined in panel-edp.c is not working for some
panels used on elm/hana devices. Move the panel node out of the aux-bus
subnode so the driver only uses the modes retrieved from the EDID.
Signed-off-by: Pin-yen Lin <treapking@xxxxxxxxxxxx>
---
arch/arm64/boot/dts/mediatek/mt8173-elm.dtsi | 26 +++++++++-----------
1 file changed, 12 insertions(+), 14 deletions(-)
diff --git a/arch/arm64/boot/dts/mediatek/mt8173-elm.dtsi b/arch/arm64/boot/dts/mediatek/mt8173-elm.dtsi
index d452cab28c67..d45a2aeb0eb1 100644
--- a/arch/arm64/boot/dts/mediatek/mt8173-elm.dtsi
+++ b/arch/arm64/boot/dts/mediatek/mt8173-elm.dtsi
@@ -90,6 +90,18 @@ switch-volume-up {
};
};
+ panel: panel {
+ compatible = "lg,lp120up1";
+ power-supply = <&panel_fixed_3v3>;
+ backlight = <&backlight>;
+
+ port {
+ panel_in: endpoint {
+ remote-endpoint = <&ps8640_out>;
+ };
+ };
+ };
+
panel_fixed_3v3: regulator1 {
compatible = "regulator-fixed";
regulator-name = "PANEL_3V3";
@@ -282,20 +294,6 @@ ps8640_out: endpoint {
};
};
};
-
- aux-bus {
- panel: panel {
- compatible = "lg,lp120up1";
- power-supply = <&panel_fixed_3v3>;
- backlight = <&backlight>;
-
- port {
- panel_in: endpoint {
- remote-endpoint = <&ps8640_out>;
- };
- };
- };
- };
};
};