On 03/24, Chao Yu wrote:
On 2023/3/24 6:03, Jaegeuk Kim wrote:
On 03/23, Chao Yu wrote:
On 2023/3/13 17:48, Yonggil Song wrote:
When using f2fs on a zoned block device with 2MiB zone size, IO errors
occurs because f2fs tries to write data to a zone that has not been reset.
The cause is that f2fs tries to discard multiple zones at once. This is
caused by a condition in f2fs_clear_prefree_segments that does not check
for zoned block devices when setting the discard range. This leads to
invalid reset commands and write pointer mismatches.
This patch fixes the zoned block device with 2MiB zone size to reset one
zone at a time.
Signed-off-by: Yonggil Song <yonggil.song@xxxxxxxxxxx>
---
fs/f2fs/segment.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)
diff --git a/fs/f2fs/segment.c b/fs/f2fs/segment.c
index acf3d3fa4363..2b6cb6df623b 100644
--- a/fs/f2fs/segment.c
+++ b/fs/f2fs/segment.c
@@ -1953,7 +1953,8 @@ void f2fs_clear_prefree_segments(struct f2fs_sb_info *sbi,
(end - 1) <= cpc->trim_end)
continue;
- if (!f2fs_lfs_mode(sbi) || !__is_large_section(sbi)) {
+ if (!f2fs_sb_has_blkzoned(sbi) &&
Could you please add one line comment here for this change?
This was merged in -dev a while ago. I don't think this would be critical
to rebase it again.
Yes, it's not critical, fine to me.
Added:
/* Should cover 2MB zoned device for zone-based reset */
So lucky since I had to rebase to fix other patch. :(
"f2fs: factor out discard_cmd usage from general rb_tree use"
Thanks,
Otherwise it looks good to me.
Thanks,
+ (!f2fs_lfs_mode(sbi) || !__is_large_section(sbi))) {
f2fs_issue_discard(sbi, START_BLOCK(sbi, start),
(end - start) << sbi->log_blocks_per_seg);
continue;