[PATCH 04/11] arm64: dts: qcom: sc7180-idp: use just "port" in panel

[Krzysztof Kozlowski]

The panel bindings expect to have only one port, thus they do not allow
to use "ports" node:

  sc7180-idp.dtb: panel@0: 'ports' does not match any of the regexes: 'pinctrl-[0-9]+'
  sc7180-idp.dtb: panel@0: 'port' is a required property

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/sc7180-idp.dts | 11 +++--------
 1 file changed, 3 insertions(+), 8 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sc7180-idp.dts b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
index c3bdd3295c02..fcabbc6a897f 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-idp.dts
+++ b/arch/arm64/boot/dts/qcom/sc7180-idp.dts
@@ -312,14 +312,9 @@ panel@0 {
 
 		reset-gpios = <&pm6150l_gpios 3 GPIO_ACTIVE_HIGH>;
 
-		ports {
-			#address-cells = <1>;
-			#size-cells = <0>;
-			port@0 {
-				reg = <0>;
-				panel0_in: endpoint {
-					remote-endpoint = <&dsi0_out>;
-				};
+		port {
+			panel0_in: endpoint {
+				remote-endpoint = <&dsi0_out>;
 			};
 		};
 	};
-- 
2.34.1