Re: [PATCH v2 1/1] ACPI: SPCR: Amend indentation

[Rafael J. Wysocki]

On Mon, Mar 27, 2023 at 3:25 PM Andy Shevchenko
<andriy.shevchenko@xxxxxxxxxxxxxxx> wrote:
>
> 1) Remove unnecessary blank lines.
> 2) Reformat one comment for consistency.
>
> Signed-off-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
> ---
> v2: avoided changind double spaces (Rafael)
>  drivers/acpi/spcr.c | 9 +++------
>  1 file changed, 3 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/acpi/spcr.c b/drivers/acpi/spcr.c
> index 01d29ebdb9c2..cd36a97b0ea2 100644
> --- a/drivers/acpi/spcr.c
> +++ b/drivers/acpi/spcr.c
> @@ -71,7 +71,6 @@ static bool xgene_8250_erratum_present(struct acpi_table_spcr *tb)
>
>  /**
>   * acpi_parse_spcr() - parse ACPI SPCR table and add preferred console
> - *
>   * @enable_earlycon: set up earlycon for the console specified by the table
>   * @enable_console: setup the console specified by the table.
>   *
> @@ -82,7 +81,6 @@ static bool xgene_8250_erratum_present(struct acpi_table_spcr *tb)
>   *
>   * When CONFIG_ACPI_SPCR_TABLE is defined, this function should be called
>   * from arch initialization code as soon as the DT/ACPI decision is made.
> - *
>   */
>  int __init acpi_parse_spcr(bool enable_earlycon, bool enable_console)
>  {
> @@ -97,9 +95,7 @@ int __init acpi_parse_spcr(bool enable_earlycon, bool enable_console)
>         if (acpi_disabled)
>                 return -ENODEV;
>
> -       status = acpi_get_table(ACPI_SIG_SPCR, 0,
> -                               (struct acpi_table_header **)&table);
> -
> +       status = acpi_get_table(ACPI_SIG_SPCR, 0, (struct acpi_table_header **)&table);
>         if (ACPI_FAILURE(status))
>                 return -ENOENT;
>
> @@ -202,7 +198,8 @@ int __init acpi_parse_spcr(bool enable_earlycon, bool enable_console)
>         if (xgene_8250_erratum_present(table)) {
>                 iotype = "mmio32";
>
> -               /* for xgene v1 and v2 we don't know the clock rate of the
> +               /*
> +                * For xgene v1 and v2 we don't know the clock rate of the
>                  * UART so don't attempt to change to the baud rate state
>                  * in the table because driver cannot calculate the dividers
>                  */
> --

Applied as 6.4 material, thanks!