[PATCH v1 3/3] PCI: brcmstb: Allow setting the completion timeout

[Jim Quinlan]

Since the STB PCIe HW will cause a CPU abort on a completion timeout abort,
we might as well extend the timeout limit.  Further, different devices and
systems may requires a larger or smaller amount for L1SS exit.

Signed-off-by: Jim Quinlan <jim2101024@xxxxxxxxx>
---
 drivers/pci/controller/pcie-brcmstb.c | 24 ++++++++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
index 129eee7bdbc1..92d78f4dfaae 100644
--- a/drivers/pci/controller/pcie-brcmstb.c
+++ b/drivers/pci/controller/pcie-brcmstb.c
@@ -1080,6 +1080,29 @@ static void brcm_config_clkreq(struct brcm_pcie *pcie)
 	writel(clkreq_set, pcie->base + PCIE_MISC_HARD_PCIE_HARD_DEBUG);
 }
 
+static void brcm_config_completion_timeout(struct brcm_pcie *pcie)
+{
+	/* TIMEOUT register is two registers before RGR1_SW_INIT_1 */
+	const unsigned int REG_OFFSET = PCIE_RGR1_SW_INIT_1(pcie) - 8;
+	u32 timeout, timeout_msec = 1000;
+	u64 tmp64;
+	int ret;
+
+	ret = of_property_read_u32(pcie->np, "brcm,completion-abort-msecs",
+				   &timeout_msec);
+
+	if (ret && ret != -EINVAL)
+		dev_err(pcie->dev, "bad 'brcm,completion-abort-msecs' prop\n");
+
+	/* Each unit in timeout register is 1/216,000,000 seconds */
+	tmp64 = (u64)216000 * timeout_msec;
+
+	/* Clamp the requested value before writing it */
+	timeout = tmp64 > 0xffffffff ? 0xffffffff : tmp64;
+	timeout = timeout < 0xffff ? 0xffff : timeout;
+	writel(timeout, pcie->base + REG_OFFSET);
+}
+
 static int brcm_pcie_start_link(struct brcm_pcie *pcie)
 {
 	struct device *dev = pcie->dev;
@@ -1110,6 +1133,7 @@ static int brcm_pcie_start_link(struct brcm_pcie *pcie)
 		return -ENODEV;
 	}
 
+	brcm_config_completion_timeout(pcie);
 	brcm_config_clkreq(pcie);
 
 	if (pcie->gen)
-- 
2.17.1