[PATCH 01/10] arm64: dts: qcom: msm8994: remove superfluous "input-enable"

[Krzysztof Kozlowski]

Pin configuration property "input-enable" was used with the intention to
disable the output, but this is done by default by Linux drivers.  Since
patch ("dt-bindings: pinctrl: qcom: tlmm should use output-disable, not
input-enable") the property is not accepted anymore.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/msm8994-sony-xperia-kitakami.dtsi | 1 -
 arch/arm64/boot/dts/qcom/msm8994.dtsi                      | 1 -
 2 files changed, 2 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/msm8994-sony-xperia-kitakami.dtsi b/arch/arm64/boot/dts/qcom/msm8994-sony-xperia-kitakami.dtsi
index 26059f861250..9dbde79f26a2 100644
--- a/arch/arm64/boot/dts/qcom/msm8994-sony-xperia-kitakami.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8994-sony-xperia-kitakami.dtsi
@@ -481,7 +481,6 @@ ts_int_active: ts-int-active-state {
 		function = "gpio";
 		drive-strength = <2>;
 		bias-disable;
-		input-enable;
 	};
 
 	ts_reset_active: ts-reset-active-state {
diff --git a/arch/arm64/boot/dts/qcom/msm8994.dtsi b/arch/arm64/boot/dts/qcom/msm8994.dtsi
index 768fe2326933..62219f73e3f9 100644
--- a/arch/arm64/boot/dts/qcom/msm8994.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8994.dtsi
@@ -840,7 +840,6 @@ i2c4_sleep: i2c4-sleep-state {
 				function = "gpio";
 				drive-strength = <2>;
 				bias-pull-down;
-				input-enable;
 			};
 
 			i2c5_default: i2c5-default-state {
-- 
2.34.1